Gift Premium Subscription To Protto

Join Date:


Last Activity:

02-08-2017 10:06 PM

Likes Given: 2

3 Likes on 3 Posts 


  • Male
  • Vangsnes
  • Norway


  • Posted in thread: SSR Question on 03-15-2016 at 04:59 PM
    Of course you can. As long as the switch can take the voltage and current.

  • Posted in thread: Brewing on a single 3-phase 16 amp circuit? on 07-07-2014 at 08:09 AM
    Your available current on the 10A circuits will be more like 16A(from each tree phase leg) /
    1.73 = 9.25A.That gives you 9.25A X 230V = 2127.5W on each 10A circuit, resulting in a total of
    6382.5W (3 ...

  • Posted in thread: I need some help from our resident electric brewing specialists on 04-11-2014 at 04:51 PM
    Why do you think you need the neutral? Is there any 110v equipment in there at all? You only
    need to connect the two hot legs and ground as far as I can read this.By the way, in other
    countries it is ...

  • Posted in thread: RIMS PID help on 02-22-2014 at 08:00 PM
    Autotuning works best when you have as real-life conditions as you can. Generally you have
    aprox the same flow from batch to batch. You may have a little more or less grains and total
    water, but that ...

  • Posted in thread: RIMS PID help on 02-22-2014 at 11:27 AM
    Did you autotune after installing the new element? It may have similar amount of power, but
    might have higher thermal mass. That could affect things. Any little change may need a
    following autotune.

  • Posted in thread: 1BBL Induction brewry on 12-13-2013 at 07:11 AM
    No problem with pot sensing as long as you keep the distance from the coil to the glass (or
    pot) as close to original as possible.As for connecting it to three phase, thats pretty
    straight forward. Th...

  • Posted in thread: 1BBL Induction brewry on 12-12-2013 at 08:59 PM
    Haha, thought that might get your attention. It's three 2kw induction cookers that I
    disassembled and mounted in a custom box. I did that to get the coils close enough to be
    covered by a 80qt stainles...

  • Posted in thread: 1BBL Induction brewry on 12-11-2013 at 11:10 AM
    I run a 6Kw induction cooker on 230vac threephase. What's not homebrew about that?

  • Posted in thread: Is a thermowell necessary? on 06-08-2013 at 06:04 AM
    The sensor in your link is already sitting in a thermowell. The SS sheathing of the probe is
    the thermowell, the sensor is inside.Empty thermowells can be used when you have a "bare"
    sensor, or a sens...

  • Posted in thread: Small container (non-HLT) HERMS tank? on 05-09-2013 at 05:41 PM
    I have one that has a 4.5m long, 8mm OD copper coil, 2kw element. It has a PT-100 on the wort
    out and is put into a stainless thermos. PID controlled and keeps mash temp within 0.1-0.2 degr
    C.It has l...