Plankton

LATEST ACTIVITY

• Posted in thread: Nitro Tap on 05-20-2012 at 11:13 AM
  I just hooked up a nitrogen tap and need advise on the beer line length. I have a mixture of
  75/25 beer-gas and it is sitting in a kegerater, which i keep at 35 degrees. Additionally, at
  what psi shou...

• Posted in thread: Hop screen help on 02-19-2012 at 04:34 PM
  Here is what I built. Works great. Plans and video on YouTube. 48751

• Posted in thread: Which BYO Fat Tire Clone is more accurate? on 02-03-2012 at 11:04 PM
  Here is the a 6 Gal batch I made for this clone. For me and my buds, it was a pretty good
  match. Before bottling, it was pretty darn close. The color was a bit darker than fat tire but
  the taste was a...

• Posted in thread: One stop shop tutorial for automated propane? on 01-28-2012 at 01:17 AM
  Anyone have a picture of the correct look of the Q314 pilot flame? The instructions only seem
  to show what it shouldn't look like.The pilot light for this should be at a 45degree angle. At
  least, that...

• Posted in thread: Weldless brew stand. on 01-27-2012 at 09:58 AM
  Just ordered the pieces! So stoked about this. My question is are there actual plans as to how
  long the cuts are?You can find the original plans for the weldless brew stand here:

• Posted in thread: Coconut Brown Ale - Help on 01-25-2012 at 02:02 AM
  I have been toying around with a coconut brown ale on Beer Alchemy. I would like to get your
  thoughts on this recipe. I am looking to go after a beer styled after Kona Brewing Co Koko
  Brown Ale.6.05 U...

• Posted in thread: 2011 1st Place HBT- Light lager- Augustiner Lagerbier Hell on 01-17-2012 at 06:28 PM
  What is the finished volume of this recipe?

• Posted in thread: New RIMS Brewery build question on 01-13-2012 at 02:51 PM
  I run a 1500 w, 2 PIDs, one 809 pump and 2 Honeywell vr8200 on one 110 circuit. You should be
  ok.

• Posted in thread: GE 7.0 Keezer Build... on 01-11-2012 at 10:35 PM
  How many kornies can fit in this?

• Posted in thread: Weldless brew stand. on 01-06-2012 at 02:42 PM
  The standing pilot HW valves are pretty simple. There are only two wires to connect and they
  come from the 24vac transformer. For my hlt I used a PID to switch the burner on/off. This
  wiring was a lit...