Last Activity:11-11-2013 6:32 PM
Posted in thread: So who's brewing this weekend? on 05-24-2013 at 08:48 PM
I'm hoping to finally get to this Milk Stout I've been sitting on.
Posted in thread: The Danby DCR412 works great! on 04-18-2012 at 02:44 PM
Yep, Diversey Brewing Company is me lol.I left the CO2 tank in the back on the hump and no
problems to report. I think I did have to unscrew and then reattached the temp control just to
a higher hole ...
Posted in thread: The Danby DCR412 works great! on 04-15-2012 at 06:28 AM
So here are my 2 pin locks fitted in. VERY tight fit. Definitely need to cut away the shelf
Posted in thread: Kenmore 461.98475 for Kegerator? on 02-19-2012 at 05:36 PM
Found a post on CL for a Kenmore 461.98475. I can't find any good information at all, but
supposedly it is 4.6 cu. ft. and outside dimensions measuring 33" high x 20.5" wide x 21"
deep.Does anyone kno...
Posted in thread: Kenmore 4.6cu ft. Kegerator Build on 02-19-2012 at 03:20 PM
Fitting the Kegs- I cut out a 6-7"wide section of the compressor hump and removed the foam all
the way to the plastic board in the back. I did this on the left side (as if you where looking
into the f...