VIEW MY

photinus

Gift Premium Subscription To photinus

Join Date:

02-17-2011

Last Activity:

09-10-2012 4:11 PM

    ABOUT ME

  • Single
  • Portland
  • OR

LATEST ACTIVITY

  • Posted in thread: Homebrewtalk Carboy Cleaner Giveaway on 12-25-2011 at 01:40 AM
    I'd love one!

  • Posted in thread: Reinforced hi-temp hose on 08-23-2011 at 06:24 PM
    I've blown a few fittings, but it was my own fault, connected the water out to the wort out on
    the plate chiller with everything still hooked up and the valve on my kettle closed, the hoses
    blow off t...

  • Posted in thread: Reinforced hi-temp hose on 08-22-2011 at 08:39 PM
    I'd be curious to see if we could rig up some reenforced tubing using something like this:
    have to add a little heat shielding to the end's near the heat source, but it would probably
    hold up pretty...

  • Posted in thread: Group Buy: Accuflex Bev-Seal Ultra barrier line on 08-12-2011 at 05:51 PM
    Thanks for organizing and facilitating the buy!

  • Posted in thread: SOF/workbench build thread on 08-01-2011 at 09:41 PM
    Subscribed, I think I'll have to do this soon in place of the workbench I was planning for my
    back porch.

  • Posted in thread: Group Buy: Accuflex Bev-Seal Ultra barrier line on 07-19-2011 at 11:03 PM
    I'll do 100 of the 3/16.

  • Posted in thread: Jabsco Cyclone Stainless Pump? on 07-05-2011 at 09:26 PM
    Maybe for something like a glycol cooler, but I wouldn't use that as a wort/beer transfer pump
    (The drive shaft comes in contact with the impeller where compared to the March pumps are
    magnetically dr...

  • Posted in thread: Mashtun - anyone ever use mesh for anchor bolts? on 05-31-2011 at 04:21 PM
    I'd guess it would work. I have a false bottom in my keggle and the holes in it are much larger
    then that (or the stainless mesh you previously used) so I would imagine it should do fine. I
    guess it j...

  • Posted in thread: Carboy/ Keg Cleaner Giveaway on 05-30-2011 at 06:50 PM
    Nice!

  • Posted in thread: Tap handle making, stumped... on 05-12-2011 at 11:26 PM
    You could try leaving yourself some overhang on all sides and then re-cutting to square based
    on the angle at which the adapter went in?If you can put the threaded adapter in far enough,
    then use some...

0 COMMENTS
POST A COMMENT