Last Activity:01-27-2014 3:01 AM
Posted in thread: Speidel Braumeister (brewmaster) on 08-24-2012 at 03:49 PM
Hello to everyone. I have been reading the message board for years, finally went out and bought
a SB. Finally showed up, got my electrical done and I am ready to go. Good news is is that I am
Posted in thread: Speidel Braumeister (brewmaster) on 08-24-2012 at 03:45 PM
Posted in thread: Speidel Braumeister (brewmaster) on 08-06-2012 at 10:00 AM
Anyone got the copper lid for 50L they want to sell?I've got one for the 20L, and other than
inverting it for a funnel for filling the malt pipe, I find it's useless:- during the boil
Posted in thread: Bench capper vs. hand capper on 08-03-2011 at 08:51 PM
I'm a bit uncoordinated, so I found the wing capper difficult to manage, and I broke a couple
of bottles while trying to cap them. When I switched to a bench capper, it was MUCH easier, and
I never br...
Posted in thread: Liquid left in pump hoses on 04-02-2011 at 01:53 PM
You can always "flush" the hoses by pumping very briefly from your HLT to the kettle to get the
last few ounces of wort out. Just a thought.
Posted in thread: Thoughts on Hoegaarden on 03-09-2011 at 07:23 PM
You should try Hoegaarden at the Hoegaarden brewery, when it's really fresh, and the Coriander
really comes through. YUM!
Posted in thread: whiskey beer on 10-09-2010 at 08:30 AM
I think what you've discovered is that whiskey is basically distilled beer.
Posted in thread: Why not just add all sparge water if the cooler is big enough? on 10-01-2010 at 11:00 AM
The real reason fly sparging more efficiently extracts sugars is that sugar will pass from the
grain to the water until the concentration of sugar in the grain is more or less the same as is
in the wa...
Posted in thread: 1/2" SS cam and groove camlocks in stock. on 09-14-2010 at 11:00 AM
Did you see the 1/2" full bore hose barb x 1/2 MPT fittings Derrin has for sale (posted today
in the Vendor Showcase)? They would go perfectly with the Type D to make a full bore hose
fitting. Just sa...
Posted in thread: New 1/2" Full Bore Barb Fittings on 09-14-2010 at 10:45 AM
Nice! This is just what is needed to go with the cam lock QDs. You rock!:rockin: