PaulB

LATEST ACTIVITY

• Posted in thread: Hello From Allentown PA on 02-08-2013 at 01:36 AM
  I have been on these forums for a few years now, but I have never introduced myself and have
  less than a handful of postings. My name is Paul Blayle and I am a mechanical engineer by trade
  which is wh...

• Posted in thread: Help troubleshooting kegerator leak on 11-22-2011 at 05:47 PM
  I got these same pieces of crap and I too and done messing with them. They are junk and I would
  not recommend buying them to anyone. I cannot see any leaks with the setup sitting in a bucket
  of water,...

• Posted in thread: RIMS Tube question... on 03-02-2011 at 05:36 PM
  Also keep in mind that rust requires water and oxygen. While water has some free oxygen in it
  things rust at a much clower rate when theyare fully submersed in water. It will rust much
  faster with som...

• Posted in thread: WTB Perlick Faucets and 4" Shanks on 12-30-2010 at 12:12 AM
  I am thinking $15 each and $5 for shipping no matter how many you want. All three could fit in
  one of those flat rate post office boxes. Let me know. I also have a 5lb tank and single gauge
  regulator....

• Posted in thread: WTB Perlick Faucets and 4" Shanks on 12-29-2010 at 12:59 PM
  I have 1 4" shank and 2 5" shanks. I don't think they are stainless. Let me know. I am in
  eastern PA so I am sure shipping will be around $5 or so.

• Posted in thread: One and Two Tap Towers on 12-29-2010 at 12:41 PM
  I need a 3" tower and I have some 4" & 5" shanks that I can trade.

• Posted in thread: WTB triple tap tower on 12-20-2010 at 05:30 AM
  I need a triple tap draft tower. Let me know what you got. I am looking for stainless and
  prefer Perlick 525 SS faucets, but would be just as happy with the tower and no faucets so I
  can add my own pa...

• Posted in thread: WTB cheap faucets and shanks on 12-20-2010 at 04:23 AM
  I got 3 sets of 5" shanks tail pieces and faucets How many do you need and what are you looking
  to spend?

• Posted in thread: Sanitary Welds - worth $20 a pop? on 09-29-2010 at 12:50 PM
  The discoloring is from dialing the welder slightly hotter than necessary. You will almost
  always get some bluing. That amount can be polished out. Remember in you quest for sanitary
  that the wost spo...

• Posted in thread: too much foam, done everything i can think of on 08-18-2010 at 01:56 PM
  Try going with 12' of 3/16" draft line and keep the beer around 38°. You should have better
  luck with that. You can look up tables to see temp vs CO2 volumes with respect to psi to fine
  tune it, but I...