Last Activity:08-23-2016 5:22 PM
Likes Given: 36
38 Likes on 30 Posts
Posted in thread: Sanke keg, foam in line. Help please! on 08-22-2016 at 02:17 PM
What zachattack said. Plus You'll need to add about 0.5 psi for every 1000' elevation you'll be
keeping the beer at for proper carbonation. So your beer line is still 5 feet to short.PapaO
Posted in thread: Frustrated with foam issues on 08-18-2016 at 03:02 AM
Alrighty... so I think adding the second o-ring can be deemed a success. Yes, the post was a
little harder to attach, but there was definitely foaming occurring around the post with just
the one (bran...
Posted in thread: Help: Why do I occassionally have zero head on kegged beers? on 08-08-2016 at 11:37 PM
It sounds like you don't have the gas on. Is there pressure in the porter keg?
Posted in thread: Corny keg portable eyewash station on 08-07-2016 at 01:54 PM
That looks nasty but on the plus side it's Stainless Steel and will clean up fine. The outside
is soap gunk not rust, the hard part is getting the sticker off. The inside has antibacterial
Posted in thread: Spike Brewing Kettle Giveaway on 07-26-2016 at 08:27 AM
Posted in thread: Pin lock conversion problem on 07-04-2016 at 08:17 PM
If it is the new posts don't fit then Baja Brewer is right. If you can't get the connector to
stay on try keg lube, if that doesn't work it could be the poppet spring is to long and needs
to be cut.
Posted in thread: Condensation problems on 06-19-2016 at 08:57 PM
You can get new Door Gaskets at
Posted in thread: Over Carbonated Keg on 05-23-2016 at 08:26 AM
It could be a hole in the diptube, works fine untill beer level goes below the hole letting Co2
in from the headspace.PapaO
Posted in thread: another foamy beer question on 05-11-2016 at 02:39 AM
Yes i'm sure. The word flow in flow control means to control the flow. You can do the samething
with line lenght so with your 70$ flow control faucet I get the same pour with 10 ft beer line
for 5$. N...
Posted in thread: another foamy beer question on 05-11-2016 at 12:42 AM
I suppose your assuming I never had longer lines,or have been through that chart,and adjusted
my line length according to that chart and had a low area in the line coil and everything else
that goes w...