VIEW MY

packet

Gift Premium Subscription To packet

Join Date:

11-08-2012

Last Activity:

07-08-2014 9:29 PM

37 Likes on 28 Posts 

LATEST ACTIVITY

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 02-18-2014 at 03:08 PM
    Ok. Still have an issue. I can smell the co2 through the top. I may not have enough silicone
    under the female screw on piece of the top. Really pissed now that I may have 13 gallons of
    wasted Rye. Hop...

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 01-28-2014 at 04:17 PM
    I've been using the cooling/heating coil since the second batch through the conical and it has
    been working great. Coldest I have been able to get it with two gallon milk jug ice blocks is
    55* with no...

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 01-27-2014 at 11:13 PM
    They're definitely bug tight. Not sure if the gamma seal lids would fit. Haven't tried to fit
    them myself.

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 01-27-2014 at 10:32 PM
    I'm sure I'll have lots more questions, but for now, it in my court as far as putting it all
    together. A huge thanks to packet and the others who've helped with my questions. It seems
    getting the coni...

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 01-26-2014 at 03:40 PM
    Question for Packet.On the neoprene. They sell a regular and a high quality version. Which did
    you use? Seems the density of the HQ stuff is higher. Have you had any problems with the
    insulation comin...

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 01-24-2014 at 07:35 PM
    That is quite the cart you've built there. I think I spent 3 hours on mine total, and more than
    half of that was finishing the wood top.

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 01-22-2014 at 07:30 PM
    I was able to determine over on the ECC forum that the BCS GND terminals are all common and
    they have three because of so many connections to GNS being required. So it really doesn't
    matter which you ...

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 01-22-2014 at 04:16 PM
    Packet,So on the "blog" site, your pictogram of the driver board wiring has the driver board
    ground connected to chassis ground.I understand a little bit about ground loops and the
    importance of not h...

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 01-22-2014 at 03:57 AM
    FYI-that Frigidaire unit Packet used is getting scarce....TDEDITAlso, Packet is right,
    soldering wire onto the XLR connectors is a PITA. I got the panel mount parts soldered up. I
    can't imagine trying...

  • Posted in thread: DIY glycol chilled plastic conical fermenters on 01-22-2014 at 03:44 AM
    I am wiring up now. The driver board connections don't seem to accept the 14ga wiring. What is
    acceptable ga? I have some 20-22ga speaker wire. Seems 18ga may even be too big. What's this
    board do? Am...

0 COMMENTS
POST A COMMENT

Newest Threads

PHOTO OF THE DAY