onlynormalguy

LATEST ACTIVITY

• Posted in thread: Almost eREADY on 05-12-2013 at 01:02 PM
  Glad to hear you're still ebrewing. I'd love to have a pint of that. AR's huh, I hope you're
  not feeling disgruntled.:)

• Posted in thread: Testing New RIMS on 03-18-2012 at 01:16 PM
  8 minutes seems pretty fast vs my 35, but that's a pretty big element. Is it a 120 or 240?
  Maybe I should get a bigger element. Do you vourloff before recirc, or do you even have issues
  with grain clo...

• Posted in thread: Testing New RIMS on 03-17-2012 at 10:56 PM
  Just finished building my new RIMS tube. I used 2" dia stainless, with a 6" nipple between the
  Tees. The element is a 120v,low density 1500 watt. Had some trouble finding an element that fit
  the NPT t...

• Posted in thread: Autosparge hole location on Keggle MT on 02-28-2012 at 02:16 AM
  Mine is mounted about a inch below the top skirt weld. I've brewed 2 10 gallon batches (18-20lb
  grain bill) with it so far and no issues.Perfect...I think that's what I'm going to do.

• Posted in thread: Word of warning : Don't Leave Full CO2 Tanks in Hot Car! on 02-18-2012 at 01:12 PM
  My Co2 Story:My neighbor who works fire suppression offered to bring home a 5lb tank. He put it
  in his sedan, then got called back inside work for a while. He got back in his car and
  proceeded to driv...

• Posted in thread: Autosparge hole location on Keggle MT on 02-14-2012 at 11:14 PM
  So far, I'm looking to drill my A.S. hole about 2" down from where the keg roof starts to
  curve. I hope this is far down enough to reach lower gravity mash scenarios. Schristian, did
  your valve open a...

• Posted in thread: Heater Element Thread Type on 02-13-2012 at 04:54 PM
  Yes, there is a variation, and the only way to be sure of a good fit is to try them out before
  purchasing.

• Posted in thread: Autosparge hole location on Keggle MT on 02-13-2012 at 04:37 PM
  I'm putting together a Mash Tun from a Bud type keg, and wondering where the best location to
  drill the hole for my Blichman Autosparge. The autosparge is adjustable for various grain bed
  heights, but...

• Posted in thread: Heater Element Thread Type on 02-13-2012 at 03:02 PM
  I'm building a RIMS tube with a 1" heater element. My stainless end cap has a 1" NPT thread,
  but heater elements have "Straight Pipe Threads" I brought my end cap to a couple of big box
  stores and a p...