VIEW MY

nugsfan

Gift Premium Subscription To nugsfan

Join Date:

11-15-2010

Last Activity:

10-24-2014 4:53 PM

Likes Given: 2

3 Likes on 2 Posts 

    ABOUT ME

  • Male
  • Married
  • Denver
  • CO

LATEST ACTIVITY

  • Posted in thread: ElectricBrewingSupply 30A BCS Control Panel Giveaway! on 10-14-2014 at 02:12 PM
    I'm in!!!!!!:mug:

  • Posted in thread: SS Brewing Technologies "That's a ton of Stuff!" Giveaway on 09-08-2014 at 10:06 PM
    To win it!!!

  • Posted in thread: Propane shutting off when turning up flow on 04-22-2014 at 10:20 PM
    It went out within a minute of firing up and only when adjusting the valve higher. I think the
    ACME nut diagnosis is probably correct. Thx.Is your regulator adjustable or just the tank?

  • Posted in thread: Wort Monster Giveaway on 04-22-2014 at 02:32 PM
    Me in!:ban:

  • Posted in thread: Triple IPA Recipe? on 04-17-2014 at 05:38 PM
    Did you brew this ever and if so how did it turn out? Did you have to age it at all or drink
    fresh?

  • Posted in thread: Spike Brewing 12.5 Gallon Conical Fermenter Giveaway! on 01-06-2014 at 03:01 PM
    To me!!!

  • Posted in thread: Any Deviant Dale's IPA Fans Out There? on 01-03-2014 at 02:58 PM
    How did this recipe turn out?Still haven't heard back but this one seems close as my memory
    recalls. Should hit the tap pretty quick. It's slightly lower in ABV at 6.58%, but thats a
    bonus for me!I br...

  • Posted in thread: Building my new Brew Stand!!! on 12-02-2013 at 04:48 PM
    The hole has already been cut, but it's not wide enough IMO and needs to be cleaned up a bit as
    the hole is quite jagged all the way around and not very uniform. Going to look at re-cutting
    the hole t...

  • Posted in thread: Building my new Brew Stand!!! on 11-27-2013 at 06:55 PM
    I guess I should rephrase the question. How wide is the hole?I'll measure it when I get home
    but I free handed it and just let the edge of the grinder run along the rim of the keg. I want
    to say it's ...

  • Posted in thread: Building my new Brew Stand!!! on 11-27-2013 at 06:53 PM
    How did u guys install your caster? I basically cut a 1.5 by 1.5 inch of 1/8 flat stock drilled
    a hole in the center and welded a nut then welded that piece to the bottom of the feet that way
    I have a...

0 COMMENTS
POST A COMMENT