VIEW MY

Noidios

Gift Premium Subscription To Noidios

Join Date:

02-18-2012

Last Activity:

04-28-2014 10:34 PM

Likes Given: 3

1 Likes on 1 Posts 

    ABOUT ME

  • Single
  • Anderson
  • SC

LATEST ACTIVITY

  • Posted in thread: Where to get Beer Gas in Greenville? on 03-18-2014 at 08:48 PM
    Did you ever find a place to swap out an a 20# cylinder for a beergas tank? I live in Anderson
    and I'm going crazy trying to find the stuff.Any suggestions on where to get a tank of Beer Gas
    in Greenv...

  • Posted in thread: Is my RIMS temp probe too short? on 03-17-2014 at 12:25 PM
    Can you take a picture of the RIMS tube layout. I had a similar problem (off by 30 degrees)
    until I switched the location of the probe and the wort return fitting to change the direction
    of the flow.

  • Posted in thread: Troubleshooting P-J's Auberin-wiring1-SYL-2352-basic5-RIMS diagram on 12-19-2013 at 03:04 AM
    Solved - I mislabeled the outputs for the heating element and the pump. Obviously the element
    was drawing more than 5 amps. Sorry to waste your time and thanks again for the help!Russ

  • Posted in thread: Troubleshooting P-J's Auberin-wiring1-SYL-2352-basic5-RIMS diagram on 12-19-2013 at 12:36 AM
    If the LED on the pump switch never comes on, there is a wiring error or you ordered the wrong
    switch. Disconnect the pump and try again to see what happens. Thanks for chiming in P-J. The
    switch is t...

  • Posted in thread: Troubleshooting P-J's Auberin-wiring1-SYL-2352-basic5-RIMS diagram on 12-18-2013 at 06:44 PM
    Hello all,I finally got around to testing this build and am having the following problems that
    I just can't figure out:fuse -5A regularly blows (the fuse feeding the pump switch)LED for pump
    never com...

  • Posted in thread: Homebrew For Heroes fund raising on 11-19-2013 at 10:40 PM
    Is the only way to help by buying a shirt? I'd rather donate homebrew. So the question is, is
    this program specific to your locality, or do you have plans to put homebrewers in contact with
    local sold...

  • Posted in thread: Auber SYL 2352 Setup on 06-30-2013 at 09:03 PM
    I am in the middle of a similar build that also uses the Auber SYL-2352 and can't find a good
    list of settings either. This is what I have gathered from other threads, but I have the
    feeling that this...

  • Posted in thread: Options for Heating Elements on 06-23-2013 at 03:35 AM
    Can you add a nipple or a length of pipe that allows the element to sit further outside the
    kettle?

  • Posted in thread: RIMS Build: Some Questions on 06-19-2013 at 01:34 AM
    Play around with a your RTD and a glass of ice water and a cig lighter. See if the temperature
    changes turn your receptacle on and off. I don't know enough about the PID to know what your
    settings are...

  • Posted in thread: RIMS Build: Some Questions on 06-18-2013 at 10:16 AM
    This pic might help explain the jumpers:At the bottom right of the pic, you can see my neutral
    (white) feeding the terminal strip where I have the label "1a". Without jumpers, the only other
    wire that...

0 COMMENTS
POST A COMMENT