VIEW MY

NoH20

Gift Premium Subscription To NoH20

Join Date:

09-07-2012

Last Activity:

10-26-2016 2:19 AM

Likes Given: 2

8 Likes on 8 Posts 

LATEST ACTIVITY

  • Posted in thread: Paint or powder coat for my new Brew stand? on 09-16-2016 at 03:03 PM
    Powder coat might not work around the burners. I added 2 layers of "heat wrap" and it's
    helping, but I think it's short term. The place I had it done said they would blast it back to
    bare and put cera...

  • Posted in thread: Methods to mark sight glass Stout Kettle on 09-10-2016 at 01:24 AM
    My Wife has a Silhouette (cuts vinyl basically). "Printed" out gallon numbers with half gallon
    "-". I put these on the metal part of the sight glass. Looks great.Todd

  • Posted in thread: BG14 - Orange flame on 06-29-2016 at 10:17 PM
    So, I finally got around to troubleshooting more. Took the burner apart, and all is good there.
    I removed the shutter completely and put some tape on the openings around the orifice. With
    approximatel...

  • Posted in thread: BG14 - Orange flame on 06-06-2016 at 12:00 PM
    It is the burner furthest away. Would orange indicate not enough oxygen though, or too much
    fuel? Or just improper mixture? It's maybe 3' of total length further.Todd

  • Posted in thread: BG14 - Orange flame on 06-06-2016 at 12:57 AM
    I've only used the stand once and it's been like this from the get go. I was hoping it was due
    to the pot being too close to the flame. But, it's the same issue with no pot. Maybe I'll take
    the shutte...

  • Posted in thread: BG14 - Orange flame on 06-05-2016 at 11:00 PM
    My stand has 2 bg14 burners few by VR8200 valves. One burner works great. The other burner I
    can't get rid of the orange flame. I've checked all the normal stuff and it's fine. I replaced
    the orifices...

  • Posted in thread: Stout kettle sparge arm - gimmicky? on 03-17-2016 at 11:26 PM
    Does anyone successfully use this? Seems like the flow necessary to get this to work is way to
    fast for sparging. I recirc with just a silicon tube laying on top of grain bed and would
    probably be bet...

  • Posted in thread: First run on new HERMS - questions on 03-12-2016 at 12:12 PM
    March 809. One item that's a waste is the Stout sparge arm. Need to run the pump too high to
    make it work. The herms process already gets a nice level of liquid over the bed. Think I'll
    skip it next t...

  • Posted in thread: First run on new HERMS - questions on 03-12-2016 at 02:54 AM
    Things were a little rocky, as expected. Learned a few things though.Not sure about the sparge
    process. Should it still take a long time, like 30-45 minutes? I went through all my sparge
    water in abou...

  • Posted in thread: Show us your sculpture or brew rig on 02-19-2016 at 03:36 AM
    Is that morebeers sampling port?Todd

0 COMMENTS
POST A COMMENT