NiteOwlBrewing

Gift Premium Subscription To NiteOwlBrewing

Join Date:

07-30-2008

Last Activity:

01-20-2014 7:52 PM

    ABOUT ME

  • Dayton, OH
  • 10gal batch APA using S04/S05
  • nada
  • Lemon Lingerie
    Lucky Pale Ale
    Standard English Bitter
  • Male
  • Married

LATEST ACTIVITY

  • Posted in thread: One pound amarillo pellets on 06-04-2013 at 02:58 AM
    Link for me too!

  • Posted in thread: What power % do you use? on 05-28-2013 at 01:07 AM
    I'm in a similar boat to Kal, but I opted not to throttle my camco 5500w at all. I'm usually at
    14g boil or so for 10-11g batches and near 19g for half bbl ones. I boil off right at 2g in
    either case....

  • Posted in thread: Going to San Diego, which brewery should I go to? on 05-24-2013 at 03:50 AM
    OK, I'm headed to San Diego for 7 days starting Saturday. Keep the brewery suggestions flowing
    if you would. I'm staying in gaslight Saturday night, La Jolla the next two and then who
    knows...

  • Posted in thread: WTB- 2 tap Perlick Beer Tower on 01-28-2013 at 06:10 PM
    I have a stainless 2 tapper with ss shanks and the older 4XX perlick forward seal faucets.
    Lines and ball locks too. Not really sure what the set up is worth honestly.

  • Posted in thread: Complete 1/2 Barrel Brewery on 01-22-2013 at 03:03 PM
    From where is that conical?

  • Posted in thread: Anyone Using RIMS for 1 BBL batches? on 01-11-2013 at 04:13 AM
    But you're losing only a few degrees F or 1-2 degrees C. My best results (coming from a lowly
    1/2bbl brewer) is to mash in with 1.1 quarts/lb and use up to the 1.3 ratio to adjust temp. I
    jack up a bi...

  • Posted in thread: Brewhemoth Triclover Chiller on 12-31-2012 at 06:26 PM
    Pm sent

  • Posted in thread: SS 2 tap tower & SS drip tray drain on 12-29-2012 at 07:30 AM
    Um, yeah...I actually have a 2 tapper insulated tower with the old forward sealing SS perlicks
    for sale if these prices are reasonable. Ball locks, bevlex and SS elbows from micromatic
    included...

  • Posted in thread: Cheap pump and FDA approved 12v 100c on 12-29-2012 at 05:29 AM
    I have one of the pumps from the OP and have been using it for several brews on my new HLT to
    recirc and fill the MLT, so it only sees water. I have it hooked to a 1amp rated supply. It is
    attached to...

  • Posted in thread: 5500w ULD element taking too long to heat on 11-28-2012 at 04:53 AM
    The surface heat lost through the sides is mildly mitigated by reflectix. So, it sounds like
    roughly the same volume assumption should be used for boil off. Wondered why beersmith has it
    as a % to vol...

0 COMMENTS
POST A COMMENT