VIEW MY

Neddy

Gift Premium Subscription To Neddy

Join Date:

08-27-2005

Last Activity:

09-13-2014 6:30 AM

5 Likes on 3 Posts 

LATEST ACTIVITY

  • Posted in thread: hefe fermenting question on 09-16-2014 at 12:53 PM
    Id bet it was underpitched.

  • Posted in thread: hefe fermenting question on 09-12-2014 at 12:48 PM
    With a proper pitch size and Temps hefe yeast will usually finish fermentation in around a
    week. You usually need a blow off tube unless your primary fermentation vessel is much larger
    than typical fo...

  • Posted in thread: hefe fermenting question on 09-12-2014 at 12:12 AM
    Definitely wait for a few more days. Two weeks, in fact, is a typically good time-frame to wait
    for primary fermentation to finish up. If you don't like waiting any extra time, you can get a
    hydromete...

  • Posted in thread: Need help with motorized mill... on 08-05-2011 at 07:46 PM
    The MM3-2.0 (my mill in the link above) has a 1/2" shaft with no keyway. It does have 3 flat
    spots milled on the shaft that the setscrew on the lovejoy coupler holds just fine. Since its a
    3 roller mi...

  • Posted in thread: My new mill station on 07-27-2011 at 04:32 PM
    you'll also need a coupler to connect the output shaft from the gearbox to the shaft of you
    milld. The one's I got are made by lovejoy. They're on page 1163 of the mcmaster carr catalog.

  • Posted in thread: My new mill station on 07-24-2011 at 09:43 PM
    Its going to a member of my club that's just starting all-grain brewing

  • Posted in thread: My new mill station on 07-24-2011 at 08:49 PM
    Got the motor off ebay. Its a 1/3hp 1750rpm GE motor. The gearbox is from Groschopp. Model RA40
    10:1 reduction. The reducer bolts directly to the motor as they're both NEMA 56C. WHen I called
    to order...

  • Posted in thread: My new mill station on 07-24-2011 at 01:44 AM
    Got tired of using a 3/8 drill with my old Barley crusher. I now have a new Monster Mill
    MM3-2.0 with a 1/3 HP motor and 10:1 right-angle speed reducer. It runs at 175rpm with 109
    in-lbs of torque. I ...

  • Posted in thread: Help wiring a RIMS control panel on 02-10-2011 at 04:07 PM
    bump

  • Posted in thread: Help wiring a RIMS control panel on 02-10-2011 at 01:22 AM
    I'm upgrading to a RIMS tube set up for my MLT. I'll still use propane for the HLT and BK. I
    only have 120v outside where I brew. I'm planning on using a PID/SSR to control a 1500w element
    in my RIMS ...

0 COMMENTS
POST A COMMENT