mullet

Gift Premium Subscription To mullet

Join Date:

10-31-2007

Last Activity:

06-22-2014 7:47 AM

2 Likes on 2 Posts 

    ABOUT ME

  • St. John's, Newfoundland
  • Computer Engineer
  • Male
  • In a Relationship

LATEST ACTIVITY

  • Posted in thread: grain mill motor on 10-16-2011 at 02:33 PM
    I purchased this motor: used it for 4 or 5 batches and been satisfied with it. Maybe a bit
    more RPM's would be nice, but it probably wouldn't really save any time.This motor is very
    common for grain ...

  • Posted in thread: Would this be a good brew pot? on 10-14-2011 at 08:24 PM
    I have to agree with Revvy. I had a 30 quart turkey fryer with safety bars sort of along those
    lines to help hold the pot in place. I found the pot a little small for full 5 gallon boils, so
    I recentl...

  • Posted in thread: Attention Canadians! Discount code! on 10-11-2011 at 02:43 PM
    I'll take a code please!

  • Posted in thread: Grain Milling Station Build and Questions on 10-09-2011 at 06:27 PM
    The capacitor in the picture was shipped with the motor. Didn't have to buy anything separate,
    just ordered the motor and it came with the capacitor. The cabinet, I have no idea. I bought it
    used from...

  • Posted in thread: Grain Milling Station Build and Questions on 10-08-2011 at 10:24 PM
    Electrical done, tested, and working! Motor turns as expected, lights come on appropriately, no
    magic smoke released!I used a connector for hooking up the tail lights of a trailer to connect
    the switc...

  • Posted in thread: Grain Milling Station Build and Questions on 10-08-2011 at 04:33 PM
    Now with the electronics mounted, but not connected yet. To cut the 22mm holes for the pilot
    lights and e-stop switch, I picked up the world's cheapest hole saw. But the top of the cart is
    covered in ...

  • Posted in thread: Grain Milling Station Build and Questions on 10-08-2011 at 03:07 PM
    If that doesn't cause issues with fitting the grain chute, that will work. The BC's chute
    screws into specific holes inside the end plates that wouldn't be accessible if the mill was
    flipped over. But...

  • Posted in thread: How to connect 2 shafts? on 10-07-2011 at 04:57 PM
    The part numbers you need are:1-3419-C 3/8" L-050 JAW COUPLING HALF 2.851-3419-E 1/2" L-050 JAW
    COUPLING HALF 2.851-3419-X BUNA-N INSERT FOR L-050 JAW COUPLING 1.70Those I got from Surplus
    Center, whi...

  • Posted in thread: Grain Milling Station Build and Questions on 10-07-2011 at 04:50 PM
    I agree, the panic button is almost definitely overkill, but I like the way they look, so I
    went for it anyway. As for the lights, they are definitely not necessary, but again, think
    they'll look cool...

  • Posted in thread: Grain Milling Station Build and Questions on 10-07-2011 at 11:51 AM
    I'll try the motor without the fan after work this evening, but on to the electrical in the
    meantime. Here is the schematic for what I am planning to do. Please excuse the sloppiness, it
    was drawn on ...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS