Last Activity:08-13-2015 3:23 PM
Likes Given: 1
2 Likes on 2 Posts
Posted in thread: Bru Gear on 03-20-2015 at 02:02 PM
If I understand, the bend is too long and it won't point straight down. If that is the case I
would think that I could cut the end to get the perfect fit.
Posted in thread: Bru Gear on 03-18-2015 at 09:43 PM
Yes, this is for a 15g kettle. I can give you the exact measurements when I get home, if you
need it.That would be great. I am looking to use it as a pickup tube on a 15 gallon kettle. It
looks like i...
Posted in thread: Bru Gear on 03-18-2015 at 09:38 PM
ndinh, you are using a 15 gallon kettle correct??
Posted in thread: Bru Gear on 03-03-2015 at 12:00 AM
ndinh, did Tim give you what the dimensions are on his standard whirlpool arm?? I was looking
to see what the measurement is from the face of the TC to the inside of the elbow. I am looking
to get the...
Posted in thread: Spike Brewing 20 Gallon Sight Glass Kettle Giveaway! on 02-02-2015 at 03:10 PM
Awesome! I'm in!
Posted in thread: Wyeast 1007 yeast rinsing question on 02-01-2015 at 07:45 PM
I was under the impression that the Wyeast 1007 German ale yeast was low floculating. I rinsed
the yeast and it is settling out like an English yeast. I am assuming that I want to pull milky
part of t...
Posted in thread: Bru Gear on 01-26-2015 at 08:59 PM
Any word on the pickup tube from them yet? I sent an email but have not heard back..
Posted in thread: Can a good bock be made with Wyeast 2007 Pilsen? on 01-07-2015 at 06:48 PM
Just brewed a Bock on Saturday using a second pitch of 2007. OG was 17p and hoping for a FG of
around 4.5 - 5. Took about 24 hours to get kicking and after 48 hours it was really churning.
Temp set @ ...
Posted in thread: BrewHardware.com RIMS hardware Kit and more Giveaway! on 01-06-2015 at 08:34 PM
Add me to the list!
Posted in thread: Bru Gear on 01-03-2015 at 10:21 PM
msjulian, Stainless cuts easily with a grinder and a cut off wheel. Also, the tri clamp
connectors on the kettles are 1 1/8" from the inside kettle wall to the outside connector, so
you'll lose some o...