Last Activity:11-12-2016 1:45 PM
Likes Given: 6
2 Likes on 2 Posts
Posted in thread: Native ESP8266 BrewPi Firmware - WiFi BrewPi, no Arduino needed! on 10-18-2016 at 01:29 AM
Yes, I used the 0.5 Version.
Posted in thread: Native ESP8266 BrewPi Firmware - WiFi BrewPi, no Arduino needed! on 10-17-2016 at 09:54 PM
I gave this a go on a brand new setup following the
V0.5 esp8266 firmware.I still couldn't get the Device li...
Posted in thread: How To: BrewPi Over Bluetooth on 06-25-2015 at 02:24 AM
I was banging my head against the wall with no responses from my HC-05 while trying to set it
in the AT mode with Arduino Serial Monitor.My module was in slow blink mode. I just wasn't
getting any res...
Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 12-21-2014 at 02:03 PM
Any one working on the DIY version of the new brewpi spark?
Posted in thread: Harbor Freight 70 Lb Scales on 12-15-2012 at 01:22 AM
I know you have returned the scale, but for anyone else fighting with a time out issue, you
just need an empty second bucket of the same type. Switch the buckets and Tare the scale again
with the empt...
Posted in thread: Harbor Freight 70 Lb Scales on 12-14-2012 at 05:08 AM
You should check out this scale, I use this at work and it's great, very accurate and doesn't
shut off automatically. Little on the pricey side,I buy them at Johnstone supply for $99.00At
work I use a...
Posted in thread: Harbor Freight 70 Lb Scales on 12-14-2012 at 02:32 AM
I got frustrated with dealing with the 7 pound capacity of my scale, so I decided to stop by
our favorite Chinese importer. The only scale there with a capacity better than I already had
was:70 Lb/32 ...
Posted in thread: 12/12/12 on 12-14-2012 at 02:08 AM
You took a nap during your boil? I would be too paranoid about something happening while the
wort was boiling.I don't think I could fall asleep.That's how I roll…
Posted in thread: 12/12/12 on 12-13-2012 at 06:54 PM
I hope it went well, I don't think I could do itYeah. Took significantly longer than it should
have. I snuck a 45 minute nap during the second half of the boil, finally got to bed around
6am. Work cal...
Posted in thread: 12/12/12 on 12-13-2012 at 06:30 AM
I was far less sensible. I didn't take off work and mashed in at 11:59 pm on 12/12/12. American
Barleywine target 1.120 sg. Work is gonna hurt tomorrow. Ugh. 90 minute mash, and 120 min boil.