Gift Premium Subscription To mrstevenund

Join Date:


Last Activity:

06-13-2015 12:22 AM

Likes Given: 2

3 Likes on 3 Posts 


  • Male
  • Married
  • Hagerstown
  • MD


  • Posted in thread: Cold Break Brewing Microbrew Series Giveaway - Open to All! on 06-28-2015 at 03:13 PM
    I'm in

  • Posted in thread: Two single setups vs one double on 04-16-2015 at 10:51 PM
    i've been thinking about getting a 2nd tank and regulator just to make it easier when cleaning
    kegs. For camping (if they allow alcohol) would be better off with a paintball tank.

  • Posted in thread: Dead Guy Clone (Extract & AG- see note) on 04-16-2015 at 01:56 AM
    I've looked through the last 20 or so pages of this post. It looks like most people are using
    WLP001 (cal ale), or pacman, or I guess to generalize it more, Ale yeast. Has anyone used a
    lager yeast, s...

  • Posted in thread: Banana Bread on 03-29-2015 at 11:42 PM
    Banana Bread Beer - Dunkelweizen (15B)BrewerSteveDate09/20/2014Batch Size5.525 galBoil
    Size6.525 galBoil Time60.000 minEfficiency70%OG1.057FG1.015ABV5.5%Bitterness21.6 IBU
    (Tinseth)Color14.6 srm (More...

  • Posted in thread: Peep cream ale? on 03-29-2015 at 02:29 PM
    It's that time of the year again when the peeps are plentiful. I recall seeing a peep beer
    recipe, I think a peep cream ale, last year. Anyone know the one I'm talking about? Google has
    let me down.

  • Posted in thread: Banana Bread on 03-29-2015 at 02:23 PM
    I did one too. I'll post when I'm on my PC later

  • Posted in thread: The case of the ghost leak on 03-23-2015 at 03:28 AM
    3rd time is the charm for my manifold. Looks like it sealed. Only thing different was to buy a
    wire brush and clean the female threads good before the rectorseal. I did see the top of one of
    my QDs ha...

  • Posted in thread: The case of the ghost leak on 03-22-2015 at 02:08 AM
    I picked up rectorseal when I switched to the dope -

  • Posted in thread: The case of the ghost leak on 03-21-2015 at 02:33 PM
    That's one moral, but another with perhaps higher value is to dunk-test everything you can
    before putting it into service. There were four different leaks in this assembly. None of them
    were due to po...

  • Posted in thread: Tips on cutting panel for controls on 03-14-2015 at 04:18 PM
    I haven't looked at the prices, but my work used to use I myself had a
    plastic enclosure. I dremeled the PID and SCR heatsink holes and used a step bit for the round


Newest Threads