Last Activity:07-19-2016 5:55 PM
10 Likes on 8 Posts
Posted in thread: Kal kettle problem with element on 08-06-2015 at 05:55 PM
If you are doing a weldless setup like kal has with the washers and silicon gaskets etc you
need to remove the rubber gasket on the element. Not sure how you are doing it so its hard to
Posted in thread: How To: BrewPi Over Bluetooth on 03-06-2015 at 06:35 PM
Plus the teensy weensy drill bits snap in half if you look at em sideways. Get extra and be
Posted in thread: How To: BrewPi LCD Add-On on 02-19-2015 at 12:44 AM
On the encoder I need to tie pin C and one of the switch pins to ground right?
Posted in thread: How To: BrewPi LCD Add-On on 02-16-2015 at 06:26 PM
And as a clarification, there is really no point in the pfet if using the rotary encoder
right?Depends... With the pfet in place, the brewpi will turn off the display after 10 minutes.
Tapping the enc...
Posted in thread: How To: BrewPi LCD Add-On on 02-16-2015 at 04:25 AM
Ok that was a PITA. My close vision is not what it used to be. My soldering Isn't what it used
to be either heh. Some sorta big blobs but hey it works. Took your placement advice Day_trippr.
Here is a...
Posted in thread: How To: BrewPi LCD Add-On on 02-12-2015 at 04:21 AM
Hopefully my encoders are on the same boat yours were :) Should get my BSS84 pfets tomorrow. I
would be interested in where you soldered yours if you do have a chance to get a pic. Thanks
Posted in thread: How To: BrewPi LCD Add-On on 02-06-2015 at 03:16 AM
day_trippr I was looking at your latest schematic and trying to wrap my head around how this
works with the PFET in there and I have a question. Since this is a PFET don't we supply V+ to
the source a...
Posted in thread: Spike Brewing 20 Gallon Sight Glass Kettle Giveaway! on 02-03-2015 at 11:34 PM
Posted in thread: How To: BrewPi LCD Add-On on 01-27-2015 at 01:48 AM
Thanks for the answer. Looks like the BSS84 pfet only comes in a SOT23 package. At least thats
all i'm finding. Now to figure out how the hell I'm going to use that.... :)