Last Activity:11-21-2014 3:19 PM
Likes Given: 2
4 Likes on 4 Posts
Posted in thread: BIAB and Beersmith on 10-01-2014 at 05:07 PM
If you already have aCooler for mashing in is there really a reason to do BIAB? I thought the
perk was single vessel the whole way.
Posted in thread: Show us your sculpture or brew rig on 09-26-2014 at 08:32 PM
I believe these are the ones that mr_rogers is referring to.Exactly the pump I was talking
about. They work very well for a fraction of the cost.
Posted in thread: Show us your sculpture or brew rig on 09-26-2014 at 05:16 AM
Posted in thread: Show us your sculpture or brew rig on 09-26-2014 at 05:15 AM
You could grab yourself a 12v solar pump online for 50-75 bucks.They have those same pumps on
eBay for 25! Shipped from California in less than three days!
Posted in thread: Need a brewing kettle.. suggestions? on 09-23-2014 at 10:04 PM
I've been reading this thread with great interest as Ive been doing One Gallon BIAB batches. My
biggest concern with scaling up my brew volume was the heating element, is it possible to get a
Posted in thread: Moving Kegs To Room Temp on 09-23-2014 at 09:55 PM
as your keg warms up the internal pressure will increase. So if you want to continue
carbonating the keg outside of your kegerator you'll need to ramp up your Co2 pressure.there
are a few Carbonation ...
Posted in thread: Do certain adjuncts restrict competition entry? on 09-23-2014 at 07:20 PM
I've brewed my third batch of "brain buster" a robust porter with vanilla beans oak chips and
bourbon. My question is about the adjuncts. Does adding adjunct like bourbon and vanilla beans
Posted in thread: Using beersmith for BIAB on 09-23-2014 at 06:21 AM
I'm pretty sure they have created a profile recently that is specifically for all grain BIAB. I
tell the program the amount of grain and it tells me the strike water. It's generally very
Posted in thread: looking for a creative solution... on 09-22-2014 at 07:29 PM
I like it! Maybe I could figure out a way to do the recirc with a short length of silicon and a
T fitting. Then remove that and just have whirlpool arm.I'm almost thinking I should get rid of
Posted in thread: looking for a creative solution... on 09-22-2014 at 07:54 AM
I was thinking about that solution. I just thought there may be a less expensive option...