mplutodh1

Gift Premium Subscription To mplutodh1

Join Date:

01-28-2006

Last Activity:

05-05-2013 4:40 PM

Referrals: 1

6 Likes on 6 Posts 

LATEST ACTIVITY

  • Posted in thread: Hello Fellow Washingtonians!! on 07-01-2012 at 05:43 AM
    Sammamish here - brewing off and on since 2005.

  • Posted in thread: Brewery Build - Single Tier HERMS on 06-25-2012 at 05:57 AM
    Hi Matt,Great thread! Thanks for sharing!Did you end up skipping the HLT stirrer/agitator that
    you mentioned back in post #25?Cheers!JeremyYup, we ended up skipping that. Didn't see much
    value in it a...

  • Posted in thread: Water Filter Setup on 06-25-2012 at 05:38 AM
    Just an FYI to anyone wanting to build this part-for-part like the OP - the Gilmour water
    shutoff has been discontinued. A slightly different part has to be used.Thanks for the heads up
    - looks like t...

  • Posted in thread: Brewery Build - Single Tier HERMS on 03-02-2012 at 12:34 AM
    Looking great! Glad the plans/details were of help, can't wait to see how it works when it's up
    and running!

  • Posted in thread: Ebenezer's Elation (Holiday Ale) Recipe - Briess - anyone have it? on 11-17-2011 at 04:14 PM
    So I misplaced the recipe card from Briess that was in an older issue of BYO. I had hoped to
    brew this recipe this weekend and will wing it based on what I remember BUT it would be great
    if anyone kno...

  • Posted in thread: Brewery Build - Single Tier HERMS on 11-06-2011 at 03:42 PM
    Yes it's 1/2 inch soft tubing - we had a coil of it from our HERMs coil so we used pieces of it
    for the sparge arm as well. Best guess looking at it they are around 1/8" bit... but you might
    just star...

  • Posted in thread: Brewery Build - Single Tier HERMS on 10-31-2011 at 04:00 AM
    1/2" copper tubing. Hole size I'd have to double check as I don't remember - I'll try and
    remember to do that tomorrow and post. As for solder - we didn't bother worrying about it and
    just used normal...

  • Posted in thread: Brewery Build - Single Tier HERMS on 10-20-2011 at 05:06 PM
    Sorry all - haven't been on here in a while due to so much going on. And sad to say, haven't
    brewed in months. Hoping to put an end to all of that BS and get back to enjoying some homebrew
    in the next...

  • Posted in thread: Brewery Build - Single Tier HERMS on 05-19-2011 at 01:57 PM
    The burners need air - without enough air they tend to be weak flames. In our case, just small
    blue tips (tiny!) but as soon as we lifted up the keg tray with the bolt head the flames grew
    to full siz...

  • Posted in thread: Brewery Build - Single Tier HERMS on 03-16-2011 at 05:35 PM
    We did end up drilling out the brass orifice that screws into the front of the burner because
    we're using propane not NG. There is a drill guide here on HBT if you search for it, think
    Kladue might ha...

Following Stats
0 COMMENTS
POST A COMMENT