VIEW MY

mors

Gift Premium Subscription To mors

Join Date:

10-09-2009

Last Activity:

01-22-2017 8:32 PM

Age:

35 years old

Likes Given: 119

100 Likes on 88 Posts 

    ABOUT ME

  • CRAFT, Sons of Liberty, and Malty Dogs
  • Male
  • In a Relationship
  • Berkley
  • Michigan

LATEST ACTIVITY

  • Posted in thread: Heating element seal on 01-07-2017 at 02:50 PM
    Sorry. I forgot to update that the washer did work. Just had to tighten the element more.

  • Posted in thread: Conical Fermentors - Stout and SS Brewtech on 01-05-2017 at 03:34 AM
    I messaged him a couple days ago... No response here as well.

  • Posted in thread: Heating element seal on 01-05-2017 at 12:36 AM
    Does the nut your using have a groove for the oring?The nut is the actual element. There is no
    groove in it. I currently have a washer between the element nut and the gasket. This was
    because the gask...

  • Posted in thread: Heating element seal on 01-04-2017 at 09:11 PM
    I am lost. Where are you using a washer with that enclosure? Where are you using a nut? Are you
    using solid wire or stranded wire for your power cord. The picture looks like solid wire.Yeah
    it's solid...

  • Posted in thread: Heating element seal on 01-04-2017 at 02:54 PM
    Haha yeah the enclosure should keep it all tucked away (if it stops filling with water...) I
    stuck an o-ring on there with keg lube... But still leaks... The element nut 'ledge' is very
    small. I'm thi...

  • Posted in thread: Heating element seal on 01-03-2017 at 02:16 PM
    Thanks guys. I was thinking about replacing the gasket. Read another thread where someone was
    saying the orings were not getting a good seal. But I believe you're right. This one is just
    too soft and ...

  • Posted in thread: Diptubes for TC Ports on 01-03-2017 at 04:31 AM
    I have a boil kettle with a 50cm diameter. Could you make one that would draw from the edge of
    the pot when installed to your Weldless Tank Bulkhead Flange?This. I love the design... but
    would want it...

  • Posted in thread: Heating element seal on 01-03-2017 at 04:07 AM
    Here's a picture.

  • Posted in thread: Heating element seal on 01-03-2017 at 04:04 AM
    It's the squared off gasket that came with the element.

  • Posted in thread: Heating element seal on 01-03-2017 at 01:33 AM
    So I'm having a bit of an issue/concern with my electric heating element installed for my
    kettle. I have the heating element installed in a tri-clamp enclosure I purchased from NorCal
    Brewing Supplies...

Following Stats
FORUM SIGNATURE
BJCP A0936 National Beer Judge and Mead Judge AHA Member CRAFT Homebrew Club Sons of Liberty Homebrew Club Malty Dogs Homebrew Club AHA Forums "dkfick"
0 COMMENTS
POST A COMMENT