Last Activity:01-19-2017 4:00 AM
Likes Given: 4
7 Likes on 6 Posts
Posted in thread: Anyone have a CAD model of a 10 gallon rubbermaid cooler? on 01-17-2017 at 05:44 AM
Just make a cube of similar dimension and radius all edges to match. If you are forced to use a
different cooler at some point it will most likely not be exact, but close enough for comfort.
Posted in thread: 1/2 Tier Brew Stand? Not sure what to call it on 01-16-2017 at 12:22 AM
Got the control panel all buttoned up. It's prepped for a future Auber dual thermometer to
monitor my chiller and brew kettle instead of dial thermometers. Still need a second pump for
hot water too.
Posted in thread: Regarding BG14 efficiency. on 01-14-2017 at 03:34 PM
Here's how I remounted my heat shield. Notice the exhaust port at the back of the shroud.
Posted in thread: Regarding BG14 efficiency. on 01-14-2017 at 03:28 PM
Yeah I have the same burner. It needs to be within the 2.5" range. That is a deign flaw of the
burner stand. I noticed looking around some of the other Bayou burners had them mounted further
Posted in thread: 1/2 Tier Brew Stand? Not sure what to call it on 01-13-2017 at 02:16 AM
quick question to the OP,I just started using the Mk II wort pump, how is yours holding up and
have you compared it to others?ThanksI love mine. I have not compared it with others as they
are all too ...
Posted in thread: 1/2 Tier Brew Stand? Not sure what to call it on 01-12-2017 at 01:39 PM
Turns out the Mypin PID was a pile of garbage. So my amazing wife gave me the go ahead to put
an Auber replacement on the credit card. :ban:
Posted in thread: 1/2 Tier Brew Stand? Not sure what to call it on 01-12-2017 at 01:19 AM
Here's an update of what the control panel will look like.
Posted in thread: What did Star San sanitizer do to my metals? on 01-11-2017 at 03:35 AM
That sucks you threw it out! It sounds like it was going well. That much blowoff that fast is a
good sign. It's the lingering slimes and crudes that you find after a few weeks that is the bad
Posted in thread: Mounting Location: Pump, RIMS Tube, Plate Chiller on 01-10-2017 at 05:18 AM
This is the system I'm working on finishing. Will be a rolling HERMS/Mash cart when done. This
way my boil kettle/burner setup is independent and always customizable.
Posted in thread: 1/2 Tier Brew Stand? Not sure what to call it on 01-10-2017 at 03:51 AM
I'm using the 30 psi regulator that came with the banjo burner. I've just interrupted it with a
solenoid valve and am running that with the PID. For the ignition I made a pilot light that
taps off the...