Last Activity:01-06-2013 3:44 AM
1 Likes on 1 Posts
Posted in thread: Feedback on my "1.5 tier" brew stand? on 02-27-2012 at 04:47 AM
Bits for the burner mount and kettle rest ready for install: welded up: issues today, mostly
due to the questionable placement of the bolt holes on my burners (standard Bayou Classic
Posted in thread: Feedback on my "1.5 tier" brew stand? on 02-26-2012 at 03:34 AM
So I guess I'll go ahead and use this as a build thread instead of starting a new one.Small
updates to the design. Hanging the pumps to keep them as low as possible to avoid priming
issues with the ma...
Posted in thread: Feedback on my "1.5 tier" brew stand? on 02-20-2012 at 06:51 PM
I'm not quite sure what the lower MLT gets you if you have two pumps. I have thought about
moving my boil kettle to near the ground so that the MLT>BK is can be gravity drain (I tend to
get stuck mash...
Posted in thread: Feedback on my "1.5 tier" brew stand? on 02-19-2012 at 11:53 PM
3 pumps?Yeah I happen to have three pumps right now, since I bought two and then got a third
with the same craigslist deal that I got the brutus steel.I haven't thought through all the
plumbing yet, b...
Posted in thread: Feedback on my "1.5 tier" brew stand? on 02-19-2012 at 04:15 AM
I only have one batch of all-grain under my belt, so I thought I'd throw this out there hoping
to get some feedback from people who have a lot more experience with this stuff.Eventually I
want to wind...
Posted in thread: HomeBrewTalk 2012 Big Giveaway on 02-13-2012 at 05:56 AM
Posted in thread: First all-grain batch + "prototype" single-tier stand on 02-12-2012 at 05:03 AM
It's been about a month since my first extract batch, and I've been itching to go all-grain.
Fueled by the determination that my first beer is actually turning out pretty well, I decided
to give it a ...
Posted in thread: Corny to Sanke Keg Help! on 02-04-2012 at 08:27 AM
I don't have firsthand experience, but they should be the same fittings as on the full size
couplers, so if you're set up to do QD's with the regular coupler, the low profile should just
Posted in thread: Corny to Sanke Keg Help! on 02-04-2012 at 08:15 AM
The first pic doesn't look so bad as long as there's not a hard kink in the line.There are also
"low profile" sanke couplings available, e.g.: this one from Amazon (no affiliation)I don't
Posted in thread: Sierra Nevada Ruthless Rye on 02-03-2012 at 03:32 AM
According to their site:Bittering: BravoAroma: Chinook & ExperimentalDry Hops: Chinook, Citra,
and ExperimentalObviously it seems like the "experimental" are proprietary, but who knows you
may be able...