Last Activity:08-13-2016 10:22 PM
1 Likes on 1 Posts
Posted in thread: Brazing cam lock fittings on 02-28-2016 at 04:35 PM
That's 135°C isn't it?Yeah, must have forgot the C...It will be good for keeping it from
burning out the element, but that's about it.
Posted in thread: How loud are the panel mount LED alarm buzzer? on 02-12-2016 at 03:38 AM
Loud enough to not think I would want it on a switch but add one during testing after I had my
Posted in thread: Brazing cam lock fittings on 02-12-2016 at 02:57 AM
Interesting idea! Have you tried it out? Do you think it will scorch the wort?The average fluid
velocity over the element is much higher than in a low watt density rims tube, I believe that
it should ...
Posted in thread: Brazing cam lock fittings on 02-11-2016 at 01:00 AM
Where did you get that heating element from? Do you know what it's wattage is, etc?Came out of
a coffee maker. It's 120V and 900 watts
Posted in thread: Brazing cam lock fittings on 02-07-2016 at 05:28 PM
I have male cams with 1/2" compression on the back. Depending on the element tube diameter, you
may be able to both connect to the element and lock into holes in the enclosure.The element
diameter is ...
Posted in thread: Brazing cam lock fittings on 02-07-2016 at 04:51 AM
Hmm. I probably will go with the house barb (type e) style, so I don't end up with a big stack
of adaptors. Might that still fit???It kind of like like there is the same amount of space on
Posted in thread: Brazing cam lock fittings on 02-07-2016 at 04:33 AM
I'm working on a little coffee maker RIMS system in a little box and am going to and try cram
some cam locks in it. It would be handy of there were some bulkhead or panel mount styles
available at a r...
Posted in thread: Parallel or Counterflow when heat with chiller on 12-30-2015 at 08:24 PM
Counter flow is more efficient. With small delta t, take everything you can get. How are you
Posted in thread: The Brew BOX on 12-27-2015 at 05:20 PM
Posted in thread: Hot Pod w/ Loud Speaker Connectors? on 12-27-2015 at 05:03 PM
Neutrik says that the SpeakOn connectors are not to be used for mains power connections. I am
not sure why. The voltage and current ratings seem adequate. They make a PowerCon32 connector
rated for ma...