millstone

Gift Premium Subscription To millstone

Join Date:

09-19-2007

Last Activity:

04-15-2014 4:06 PM

Likes Given: 2

2 Likes on 2 Posts 

    ABOUT ME

  • In front of my computer in Hammond IN
  • Retired, but still drinking
  • Male
  • Married

LATEST ACTIVITY

  • Posted in thread: Sorry Martin... B'N'W problem on 03-30-2014 at 04:03 PM
    I used my gram scale and a small cup of water. I first weighted the cup of water, then poured
    in water to the 2ml mark on the injector/dropper and re-weighted the cup. Did the same from 4ml
    up to 10ml...

  • Posted in thread: Sorry Martin... B'N'W problem on 03-30-2014 at 03:48 PM
    Ken, have you checked/calibrated your "dropper"? I use a 10ml injector that I calibrated by
    measuring various amounts of water and weighing them. If I'm correct 1ml of water should weigh
    1gram, but no...

  • Posted in thread: MM2 Mill powered with Garage Door Opener? on 03-24-2014 at 11:54 AM
    "I have to say thats a sweet setup. is that an adjustable Schmidling mill?"No it's the original
    Monster Mill, bought it in 2007. and thanks for complement.--------------"Nice setup! Did you
    build the ...

  • Posted in thread: MM2 Mill powered with Garage Door Opener? on 03-23-2014 at 12:31 PM
    Finally got to try out the new motor, did two brews on it. The first one was about 21lbs of
    grain, the second was about 19lbs of grain. My setup has an on/off switch, pilot light and a
    three way switc...

  • Posted in thread: MM2 Mill powered with Garage Door Opener? on 03-02-2014 at 03:43 PM
    Make sure the allen screw is not stopping the coupler from sliding onto the shaft, also put a
    little bit of lub on the shaft, it made it easier for me to slid on. The only filing I did was
    to make a f...

  • Posted in thread: ebay aquarium temp controller build on 02-28-2014 at 12:31 PM
    The copy/ paste workedTomSent from my iPhone using Home Brew

  • Posted in thread: ebay aquarium temp controller build on 02-28-2014 at 02:54 AM
    Same with meTomSent from my iPhone using Home Brew

  • Posted in thread: MM2 Mill powered with Garage Door Opener? on 02-25-2014 at 10:02 PM
    It took about 4 minutes to kick out, I did not have a fan installed during that test. I
    probably let it sit for 10 minutes before running it again. But remember I was doing a no load
    test just to see ...

  • Posted in thread: MM2 Mill powered with Garage Door Opener? on 02-22-2014 at 10:09 PM
    Yes, I'm using a worm gear to reduce the motor speed. During my first test, I was switching the
    motor from forward to reverse a number of times, so that could have caused the geyser I had
    coming from ...

  • Posted in thread: MM2 Mill powered with Garage Door Opener? on 02-16-2014 at 05:45 PM
    The cap and motor are about 15 years old, maybe it was just time. Did have another cap, about
    the same age, tested it under no- load. The motor timed out after about 4+ minutes, the motor
    temp was abo...

0 COMMENTS
POST A COMMENT