Last Activity:01-06-2017 10:12 PM
Likes Given: 23
16 Likes on 15 Posts
Posted in thread: Keg mash tun design on 12-07-2016 at 05:59 PM
If you didnt mind a hole, I would cut the hole in the workbench. Have your keg fitting, valve
straight down, then a quick disconnect on that so you can unhook the hose and move the mash tun
Posted in thread: Help find a HERMS picture on 12-02-2016 at 02:22 PM
It looked like the coil exits were on the side of the kettle, and the valves and everything
turned to face the front. It may have been like that, but with the tee attached to the kettle
fitting with t...
Posted in thread: Help find a HERMS picture on 12-02-2016 at 04:57 AM
So I am trying to decide on mounting my herms coil. I do want to have a temp probe or
thermometer on the output of the coil. I did see a picture on here that was very nice, i think
they used a tee or ...
Posted in thread: Milesvdustin's electric brewery build on 11-17-2016 at 06:55 PM
Life got CRAZY and many things happened in the last Four years! I had a son, took orders to
recruiting, and subsequently got out of the Marines. I finally dug all my brew stuff out of
storage (yeah, n...
Posted in thread: My electric HERMS build on 12-22-2013 at 10:03 PM
Weld less is perfectly fine for your build. I also have a three keg two pump herms (mine is 30
amp, but I don't need to run two elements at once. ) mine is all weldless.
Posted in thread: Anyone tried this timer in their CP? on 08-30-2013 at 10:37 AM
The only bonus to my asl 51 is I got to add more switches to my panel for reset and pause
functions. Looks boss.
Posted in thread: Hey Bartender, can I get some foam to keep my beer cold? on 07-25-2013 at 02:13 PM
That's why I like NASCAR races so much, you bring your own cooler of beer!
Posted in thread: Cost of a typical E-system on 03-15-2013 at 09:11 PM
I made a one pid panel with a timer and a switch that controls two elements. I have two ss
chugger pumps and three keggles with electric in two of them. I still need a stand, and about
400 bucks in fi...
Posted in thread: Making hole for element question on 02-02-2013 at 04:48 PM
Step bit for sure. I used motor oil for lube and made good holes.
Posted in thread: $15 off 1/2" coils starting Turkey Day!!! on 02-01-2013 at 04:53 PM
Score! Just in time for when I was going to purchase one!