mikewildt

LATEST ACTIVITY

• Posted in thread: Steps when rekegging a home brew corny keg??? on 10-30-2010 at 05:49 PM
  I remove everything.So do you use PBW (Brew Wash) and something like Iodophor each time? Or do
  you just sanitize each time unless it needs to be clean. It's not like the keg has been sitting
  around I ...

• Posted in thread: Steps when rekegging a home brew corny keg??? on 10-30-2010 at 05:20 PM
  I finished my first batch of home brew and am going to refill my 5 gal ball lock corny keg with
  a new batch. Obviously I am going to remove the leftovers from the bottom of the keg, and
  sanitize the e...

• Posted in thread: Converting the Frigidaire 7.2 cu ft Chest Freezer on 09-30-2010 at 06:17 PM
  Mike,Read my reply #56. That paint is pure gold! :)JohnDid you have to sand it down, or did you
  paint right over the factory paint?

• Posted in thread: Converting the Frigidaire 7.2 cu ft Chest Freezer on 09-30-2010 at 05:45 PM
  I did have another question: What size hole saw for the shank holes? I think I read somewhere
  else the 7/8" works best. Can you guys confirm?JohnI used the 7/8" bit and the shanks fit tight
  and perfec...

• Posted in thread: Converting the Frigidaire 7.2 cu ft Chest Freezer on 09-23-2010 at 05:34 PM
  Quaffer/Mike...Did you guys do anyhting to seal/insulate the backside/inside of the temp
  controller? Do you think there is an problem with condensation getting into the unit from the
  back since it is ...

• Posted in thread: Converting the Frigidaire 7.2 cu ft Chest Freezer on 09-17-2010 at 11:48 PM
  Awesome! Thanks Mike.One more question...did you have to sand the freezer down to metal or did
  you spray right on top of the existing finish? I would really prefer that the end result be a
  textured fi...

• Posted in thread: Converting the Frigidaire 7.2 cu ft Chest Freezer on 09-17-2010 at 02:42 PM
  mike...what type of paint did you use? I would still prefer to buy a used freezer off of
  craigslist rather than fork over $250. Are you satisfied with the paint?Hi John,I used
  Rust-Oleum Appliance Epo...

• Posted in thread: Did I mess up my first brew? on 08-20-2010 at 06:06 PM
  Nope, but you messed up in the area of forum etiquette! :pI know I am trying to figure out how
  to delete the post out of the General Brewing questions forums, noob mistake. Should have just
  been poste...

• Posted in thread: Did I mess up my first brew? on 08-20-2010 at 05:27 PM
  According to your recipe, 1 oz of centennial should have gone into the brew pot when you turned
  the burner off, and the 2 oz should go into the secondary for about a week, I dry hop in the
  keg so my p...

• Posted in thread: Did I mess up my first brew? on 08-20-2010 at 05:10 PM
  This is my first batch brewing. I brewed this last night, added the yeast and put the batch in
  the glass carboy. Here is the recipe I was following.Grain Bill13 lbs. - 2 Row Pale Malt1/2 lb.
  - Crystal...