Gift Premium Subscription To Mightyscoop

Join Date:


Last Activity:

09-01-2014 8:14 PM

Referrals: 1


  • Single
  • Marietta
  • GA


  • Posted in thread: Its finally here!! (Yes, yet another build thread...) on 04-07-2012 at 11:36 PM
    What kind of tri-clamp fits to the sanke fitting? I don't know that I've seen this done before!
    I also really dig the control box. Reminds me of the digital trainer we got in school.

  • Posted in thread: Do you really need a control panel for e-kettle? on 04-07-2012 at 02:18 PM
    If you're hell-bent on not building any sort of controls you may be better off forgetting about
    10g batches and just going with a 2000W-ish 120V element for 5g batches. You could run that
    full blast a...

  • Posted in thread: Electric Brew Kettle on a Budget on 03-11-2012 at 06:22 PM
    There are minimum spacing requirements in electrical equipment to prevent arcing phase to
    phase. (Read possible really big explosion) You should really find a piece of plastic or rubber
    to put between...

  • Posted in thread: Efficient Octagonal CPVC manifold for Rubbermaids on 02-20-2012 at 11:35 AM
    Carter, Looks great. The only thing I may be worried about is the torched piece. Correct me if
    I'm wrong, but heating and bending the CPVC like that may release some nasties. I know for sure
    it did wh...

  • Posted in thread: Too dry for a Belgian Tripel? on 07-18-2011 at 12:08 PM
    The sleeping beast has been disturbed! Well, just about 4 months after brewing this tripel, I'm
    still aging it. It's sitting carbed in a keg as I speak. The fusel alcohol has dropped pretty

  • Posted in thread: Too dry for a Belgian Tripel? on 04-13-2011 at 05:36 PM
    Thanks for the comments folks. As far as calibration of my hydrometer goes, it's fine. 1.000 in
    distilled water, and it confirmed the 1.004 with my buddy's refractometer. As I said in my OP,
    I'm not e...

  • Posted in thread: Too dry for a Belgian Tripel? on 04-10-2011 at 08:15 PM
    I brewed a Triple based off of The Dragonmead Final Absolution Clone 3 weeks ago today. Here's
    the recipe I followed:Brew Type: All Grain Date: 3/19/2011 Ingredients Amount Item Type % or
    IBU 14.50 lb...

  • Posted in thread: Deception Cream Stout on 03-11-2011 at 03:28 PM
    Well, I brewed this on Jan 17th and started cracking bottles last night. LOVE IT! It finished
    pretty dry (1.010) due to missing my mash temp. Even though it's a bit dry it's still creamy
    and smooth. T...

  • Posted in thread: Cannot Solder to save my life on 03-04-2011 at 05:02 PM
    When soldering, make sure you're heating the part that is to be soldered. When the part is at
    the right temp, the rosin-core solder will run effortlessly onto the joint. I know when I first
    started so...

  • Posted in thread: SS vs Aluminum brewpot on 01-26-2011 at 04:22 PM