- Posts 55
Last Activity:04-23-2014 1:19 PM
4 Likes on 4 Posts
Posted in thread: Element duty cycle - What do you run at? on 03-14-2014 at 06:47 AM
I have been setting my boil element at 60% with 13 gallons & and a 5500watt camco.Sent from my
EVO using Home Brew mobile app
Posted in thread: Ebrewing and dyer switch? on 03-14-2014 at 06:17 AM
Don't see any problems there.Sent from my EVO using Home Brew mobile app
Posted in thread: Electric Brewing Question Please on 03-08-2014 at 03:31 AM
Good job catching the relay wiring. Its all easy to do wrong. The one wire in the wrong place
is what tears up equipment and shocks people. What country are you in? Don't forget to double
check the wi...
Posted in thread: Electric Brewing Question Please on 03-06-2014 at 03:33 AM
Good job! Any plans of adding gfci protection? Just curious...
Posted in thread: 240v Receptacle On Element Box? on 03-05-2014 at 05:08 AM
Just search for twist lock "inlet" . You will find what you need.Sent from my EVO using Home
Brew mobile app
Posted in thread: Electric Brewing Question Please on 03-05-2014 at 01:59 AM
The only other thing I see is that your switch wiring might need some adjusting. I just looked
at one of my switches and the wires bringing the power in (line) need to both be on either the
Posted in thread: Ebrewing and dyer switch? on 03-04-2014 at 05:12 AM
But I guess you could get a 30 amp motor control switch that has three taps. When the switch is
in one position the dryer gets power the other position the rig gets power. I'm not talking
about the th...
Posted in thread: Ebrewing and dyer switch? on 03-04-2014 at 05:04 AM
This might not be a cheaper option but look at generator panels that have the main breaker back
feed on the bus bar. Some have a bracket that holds the handles of two breakers, one being the
Posted in thread: Electric Brewing Question Please on 03-04-2014 at 04:11 AM
Sorry if this is a double post. It looks like the your fan and the circuit board at the top of
your box is on the load side of your ssr. If they are then you will want them wired off the
switch. I may...
Posted in thread: Question from on of PJs diagrams before I begin build. on 02-27-2014 at 04:11 AM
If you use the pid in manual mode it doesn't use the temp sensor to control the element. You
won't be able to monitor the boil temp with the pid but you will be able to control the boil.