Last Activity:11-05-2014 11:03 AM
Posted in thread: Best Filtration Before Plate chiller on 05-25-2012 at 08:30 PM
Nope, and I'm using a keggle too. I don't see how you could get scorching unless you forget to
kill the flame before draining and burn it once almost empty. Otherwise the volume of liquid
should keep ...
Posted in thread: WTB: 10 Gallon Corny Keg on 04-10-2012 at 12:20 AM
Anybody have a 10 gallon corny they'd be willing to part with? Ideally in the San Francisco
area or willing to ship here for a reasonable price. Thanks.
Posted in thread: Best Filtration Before Plate chiller on 02-20-2012 at 04:02 AM
Whole hops and a false bottom in my boil kettle. Works great.
Posted in thread: Switches for 20 amp outlets... on 01-06-2012 at 12:26 AM
I'm far from an expert here, but it sounds like you just need a couple of DPST switches.
Something like these:4-BLADES, ON/OFF, CHROME HANDLE, MEDIUM DUTYEach switch has two poles so
you can use one s...
Posted in thread: MoreBeer Keg Washer on 12-29-2011 at 05:59 AM
I actually just received one of these today. I'm pretty happy with it. I do agree that you
could probably build it either a bit better or a bit cheaper yourself. But, in this case I've
got enough othe...
Posted in thread: How best to run grounds with a plastic enclosure on 12-15-2011 at 06:12 PM
I'm building a fairly basic RIMS system based on one of PJs excellent schematics. I've noticed
most people use metal enclosures with a ground lug, but my enclosure will be plastic. In this
Posted in thread: Done with March pump on 09-13-2011 at 05:34 AM
Have a look at those tables again then, for roughly the same pressure lose @ 2 GPM through 3/8"
tube you would get 4 GPM through 1/2" tube (0.08 vs 0.092 PSI/ft)Basically with the 3/8" CFC i
see you l...
Posted in thread: Done with March pump on 09-13-2011 at 05:29 AM
I just made this really crappy vid to show the flow of the 809-HS with the 815 impellerThanks
for the video. There is no chiller inline there right?
Posted in thread: Done with March pump on 09-13-2011 at 05:21 AM
OK good to know the silcon is 1/2" ID.What sort of flow rate are you looking for? This is a big
factor in sizing not just you pump but the rest of the piping, etc.Look at this table (3/8"
tube), as an...
Posted in thread: Done with March pump on 09-13-2011 at 04:56 AM
This is the info we were all asking for at the beginning!If you had told us all this most would
say "yes, you might be pushing it a little for the 809HS".Sure, but I wasn't asking for
opinions on if t...