Last Activity:04-13-2010 8:57 AM
1 Likes on 1 Posts
Posted in thread: Flaked Oats on 02-25-2007 at 03:06 AM
Thanks for the link! allready read the thread though.(been doing lots of research on gluten
free beer) and decided to go my own route. my plan is to make a non wheat/Barley verrsion of
Posted in thread: Flaked Oats on 02-25-2007 at 02:51 AM
I posted a quesion about flaked Oats in the general discussion forum, but i think you all-Grain
wizzards may be able to provide me with more insight
Posted in thread: Flaked oats on 02-25-2007 at 02:26 AM
so you dont think that amalise will aid in conversion?
Posted in thread: Flaked oats on 02-25-2007 at 02:19 AM
I would just steep it with about a half pound of DME just to make sure it converts.Cant use DME
cause of the gluten. this beer is going to be Sorghum based
Posted in thread: Flaked oats on 02-25-2007 at 02:16 AM
another question about oats. Can i use off the shelf oatmeal? the reason i ask is because oats
and wheat are grown in alternating rows, and during harvesting, whe wheat can contaminate the
Posted in thread: Flaked oats on 02-25-2007 at 01:53 AM
O.K. I use and enjoy this site way too much to just "float by". I joined as a gold member!
Posted in thread: Flaked oats on 02-25-2007 at 01:06 AM
I found a recipie for some beer that uses flaked oats. How and when do i use this ingredient?
If i am using it with extract brewing, should i use amilaise? Primary:
Posted in thread: mini cold box project. on 02-10-2007 at 03:01 AM
long time no post, but it's good to see you have made so much progress!. my idea for a door
seal uses magnetic tape. it's available at craft stores. i think most fridge seals use flexible
Posted in thread: Kenmore wiring problem on 02-10-2007 at 02:43 AM
"C" probably goes to the compressor, and "L" is probably line voltage (hot), but as jager said,
it's only a temperature controlled switch, so it dosent really matter
Posted in thread: Wire feed MIG welder recommendation on 02-10-2007 at 02:36 AM
Look up steel in the yellowpages. there are at least 20 different whosale/retail steel
distributors in my area. Usually the larger ones will sell " drops" ( pieces cut off of "custom
length" orders) a...