Last Activity:04-14-2015 3:46 PM
Likes Given: 2
62 Likes on 43 Posts
Posted in thread: Gas control/pilot light on 04-10-2015 at 10:46 AM
That is a low pressure propane valve designed to run at 11" water column. Good chance you may
have damaged the valve if you put 30 PSI to it. Is your burner a low pressure burner? Start
with a low pre...
Posted in thread: Anyone use a table? on 02-17-2015 at 10:08 AM
My brew system started as a chefs table and I love it. The casters are usually the a weak link
and could be removed if needed. You could always beef the table up with more supports or watch
Posted in thread: The MaxOut Brew Station on 02-10-2015 at 09:26 AM
Very impressive. I would like to do something like that but would need to get divorced first or
if I started doing it, would surely get divorced halfway through. At least I could use her
Posted in thread: The MaxOut Brew Station on 02-09-2015 at 04:58 PM
Posted in thread: The MaxOut Brew Station on 02-09-2015 at 04:53 PM
I just joined HBT just so I can comment on your setup / thread. I went through the thread this
morning in it's entirety and am blown away! Nice work on your ingenuity and dedication. Along
Posted in thread: Cheaper alternative the the Thermapen on 11-07-2014 at 10:08 AM
I will post my own test results once I receive it and have it tested. Thanks again.MaxOut
Posted in thread: Cheaper alternative the the Thermapen on 11-06-2014 at 09:57 PM
Just be sure to test its accuracy and recalibrate if necessary. After having read all the good
things about the ThermaPen and having already had the far cheaper RT600C, also from
ThermoWorks, I figure...
Posted in thread: Cheaper alternative the the Thermapen on 11-06-2014 at 08:37 PM
I use the BCS with thermistor temp probes that are calibrated by recording the resistance at
three know temps. Generally you will measure 32F (ice in Water) 212F boiling water at my sea
level but the ...
Posted in thread: Cheaper alternative the the Thermapen on 11-06-2014 at 06:47 PM
Thanks for all the responses. I ordered a CDN and a Thermapen. I am not one to skimp but just
wanted to be reassured the Thermapen was as accurate and quick as stated. After I calibrate I
will use the...
Posted in thread: Cheaper alternative the the Thermapen on 11-06-2014 at 12:29 PM
interesting data...MaxOut BrewStation