Last Activity:10-17-2016 2:02 AM
Likes Given: 4
15 Likes on 5 Posts
Posted in thread: NEW StrangeBrew Elsinore Thread on 09-17-2014 at 07:20 PM
why would I be able to open 192.168.xxx.xxx:8080/console but not open hostname:8080/console? I
thought I was losing my mind trying to use the address that was displayed after start up, then
I decided ...
Posted in thread: all grain full set up on 04-15-2014 at 08:57 PM
How much for the cornmill shipped to 74146
Posted in thread: Induction hob on 03-26-2014 at 02:04 PM
I have one of these and it works great for cooking with the right cookware. What I have found
with it most pots will not work with induction cookers. However you can buy one of these
Posted in thread: Knockout punch on 03-24-2014 at 04:21 AM
I will let you know I am going to purchase these tomorrow. I have bought lots of stuff from HF
and never had any issues. But then again I don't plan on using these on a daily.
Posted in thread: Raspberry Pi StrangeBrew Elsinore Basic Setup on 03-17-2014 at 09:42 PM
Found this site today and thought it would be a good site to share.Talks about 1-Wire
ThermometersHope this helps someone that is confused about the 1 wire probes.
Posted in thread: HomeBrewTalk 2014 Big Giveaway on 03-13-2014 at 04:12 PM
Count me in on this awesome collection.
Posted in thread: Raspberry Pi StrangeBrew Elsinore Basic Setup on 03-10-2014 at 06:21 PM
I am jumping on this band wagon too, I know the Linux side pretty well but the programming and
electrical side is my weakness. I have a laundry room to brewery conversion in progress and all
Posted in thread: Is this wire any good? on 03-10-2014 at 02:17 PM
solid wire is not going to be the best for elements. Not saying you cant use it, but it will be
very stiff. Save your self the troubles and get the stranded wire.
Posted in thread: BCS with Stout on 03-07-2014 at 08:58 PM
I am almost 100% sure that they do not make these. These are ordered from china and then
shipped I was looking at buying some from here...Look familiar? I could be wrong. Either way
I do like them....
Posted in thread: BCS with Stout on 03-07-2014 at 08:21 PM
So the kettle should be this one They all look like the use a 2-4" welded thermowell with a
1/2" npt fitting on the outside of the kettle. so depending on the temp probe you purchase you
may or may ...