Last Activity:07-16-2016 12:54 PM
4 Likes on 3 Posts
Posted in thread: Chugger/March Pump Housing Template on 05-31-2016 at 07:28 PM
Is there a trick to getting this template to print at the right size? when i print it on a 8.5
x 11 no matter what orientation it prints to large
Posted in thread: BrewsBySmith 2 stage Fermentation Temperature Controller Giveaway! on 10-23-2014 at 03:56 PM
Posted in thread: Condensation in keezer on 10-01-2014 at 05:45 PM
No i dont typically open it alot. maybe ill try playing around with the temps
Posted in thread: Condensation in keezer on 10-01-2014 at 02:23 PM
Hey,I use an Eva-Dry in my keezer and have a recirculating fan and im still getting a lot of
condensation. Any ideas as to why this might be or what i can do to remedy it? I have a good
seal around th...
Posted in thread: magnets & brackets for drip tray on 04-29-2014 at 12:10 AM
For those of you who painted your keezer black, do any of you have problems with strong magnets
scratching the paint?I did, I have to repaint mine, I found it was due to moving the drip tray
Posted in thread: Wattage Calculator for Hot Water Heater Elements on 04-19-2014 at 03:07 AM
Posted in thread: Wattage Calculator for Hot Water Heater Elements on 04-18-2014 at 06:55 PM
I have a spreadsheet that calculates the stuff for you.. you still have this spreadsheet?
Posted in thread: magnets & brackets for drip tray on 04-18-2014 at 12:53 PM
Magnets came from Harbor Freight, I think these are the same thing via Amazon: had 4 full
pints on it. These magnets are strong, they actually pull the tray out of my hands when I get
within an inch ...
Posted in thread: magnets & brackets for drip tray on 04-16-2014 at 05:11 PM
Not sure if you have already mounted yours but here was my solution: that looks really clean!
Where did you get those magnets? I've been using hard drive magnets and they've been working
well but I w...
Posted in thread: "polishing your keg" is more than a clever euphemism on 03-29-2014 at 10:49 PM
Sorry if this has been asked before, but bobby_m's website doesnt load anymore, are there
instructions somewhere else without reading the 50+ pages? :) I will if i have too though!I got
a grinder, bac...