mattreba

LATEST ACTIVITY

• Posted in thread: brewtroller website? on 06-26-2012 at 03:27 PM
  Our apologies. We just made the swap over on the site and are trying to migrate and update
  information. We've also just updated the product offerings so there is a significant amount of
  updates needed...

• Posted in thread: Brewtroller bubbler on 12-16-2011 at 11:22 AM
  The sensor measures the amount of pressure caused by the height of the liquid in the vessel.
  There is air in the line as the sensor does not directly contact the liquid. When the
  temperature increases...

• Posted in thread: Is there a brew club in Portland ME? on 06-20-2011 at 03:24 PM
  I just got back from NHC and I need to put in a big me too. I'm subscribing to this thread. PM
  me if you know something or just want to get together.

• Posted in thread: BCS 460 vs Brewtroller - what say you?? on 06-04-2010 at 02:14 PM
  One piece of advice for the brewtroller, if I google it, I want to see a simple explanation of
  what it does. The website sucks.I think we can do better. Thanks for the feedback.

• Posted in thread: BCS 460 vs Brewtroller - what say you?? on 06-04-2010 at 01:09 PM
  Obviously as one of the developers for BrewTroller I'm biased. I do think the DIY component of
  BrewTroller is made into a bigger issue than it really is. The BCS comes with an enclosure and
  power supp...

• Posted in thread: Computer Controlled Relays w/ Temp Sensor on 03-31-2010 at 01:33 PM
  dozer: Absolutely. I was referring to the item in the intial post. If the intent was to go
  toward BrewTroller, spending $40-60 on a temporary alternative versus the $80 for BT might not
  be the best ch...

• Posted in thread: Computer Controlled Relays w/ Temp Sensor on 03-31-2010 at 12:09 PM
  This isn't much cheaper than a BrewTroller. Keep in mind you don't need to use every feature of
  BrewTroller when you start. You can use it to monitor temps and control a few pumps.

• Posted in thread: brew system controller featured in hackaday on 09-02-2009 at 08:31 PM
  The project started here on HBT as a matter of fact :)

• Posted in thread: Strike Volume Measurement on 08-19-2009 at 10:16 PM
  BrewTroller does this though it's not something that's been tested very thoroughly yet. We use
  the Freescale MPX5010 sensor and a calibration table in setup where you calibrate specific
  analog voltage...

• Posted in thread: All Electric Brewing System with Steam on 03-27-2009 at 02:37 PM
  Has anyone figured out how to make a cheap steam jacketed boil kettle yet? You could eliminate
  the elements in the boil kettle and use a boiler for direct mash heat and to feed the kettle
  jacket.