matiasek

LATEST ACTIVITY

• Posted in thread: Direct Fire MLT Insulation Project on 02-22-2012 at 06:19 PM
  I did the same thing, holes were slightly too big, but I filled in those holes with silicone
  and have had not problems with the silicone melting or burning.

• Posted in thread: Accuflex Bev-Seal Ultra barrier line 3/16" on 10-21-2011 at 07:35 PM
  The tubing is available to order on the website!You can get it here: Thanks Birdman!

• Posted in thread: Accuflex Bev-Seal Ultra barrier line 3/16" on 10-20-2011 at 02:27 AM
  Yes that size is worth a try, let us know how it goes. However I believe a shank tailpiece barb
  is incompatible with a 1/4 FFL nut. I see that beverage factory carries the 3/16 barb for a 1/4
  FFL fitt...

• Posted in thread: Accuflex Bev-Seal Ultra barrier line 3/16" on 10-19-2011 at 04:07 PM
  Epic fail. :(Is there a source of stainless 3/16" flared fittings with 1/4" threaded connectors
  out there? I'll gladly put clamps on the lines if that's all it takes.Williams brewing just
  started carr...

• Posted in thread: Accuflex Bev-Seal Ultra barrier line 3/16" on 10-18-2011 at 07:12 PM
  Thanks for your candid response. It is very generous of you to offer it so deeply discounted.
  As much as I hate to say it, I would encourage you to make it more worth your while. That way
  you have a r...

• Posted in thread: Accuflex Bev-Seal Ultra barrier line 3/16" on 10-14-2011 at 11:20 PM
  Looks like this is the tubing to get to keep beers tasting fresh in the lines. I do not
  currently have any issues with most of the beers that I poor, but anything that I poor
  infrequently (monthly) st...

• Posted in thread: Direct Fire MLT Insulation Project on 10-07-2011 at 03:38 AM
  If it were similarly priced I would have been interested (should I ever need to rebuild this)
  but I think that it really bends just fine on its own. Most of us are using Bobby's spec with
  the silicone...

• Posted in thread: Direct Fire MLT Insulation Project on 10-02-2011 at 05:21 PM
  I used my biggest drill bit to cut through the aluminum, then used a grinding attachment on my
  drill to grind it our to the appropriate size. This was much cheaper than buying a larger drill
  bit. The ...

• Posted in thread: Direct Fire MLT Insulation Project on 07-06-2011 at 08:37 PM
  I think the key is to get the aluminum "pre-bent" as best you can. Every time you bend the
  insulation around the kettle it breaks down a little, and this will be more so without the
  adhesive. I kept h...

• Posted in thread: Direct Fire MLT Insulation Project on 07-06-2011 at 08:01 PM
  I would try to avoid using the spray adhesive if possible. Thats my only beef with the original
  design. It has been a little stinky when direct firing the mash tun but manageable.