Last Activity:11-21-2014 11:00 AM
Likes Given: 3
16 Likes on 11 Posts
Posted in thread: how do I prep my DIY oak mash paddle for use? on 11-02-2014 at 03:05 AM
while I agree that red oak is not the ideal type of wood for a mash paddle, I've been using
mine for over a year now without any problems. No oil was used and I just rinse it after use
that's all. At ...
Posted in thread: Harvesting/washing (high flocculant) wyeast 1968 on 10-06-2014 at 12:30 PM
The video is interesting regarding the 24h time on a stir plate but what if you have a 4-5
months old package. I don't think you'll see any activites if you let the starter on the stir
plate for 24h. ...
Posted in thread: New Stainless Steel Mash Tun on 09-29-2014 at 01:52 AM
I did something very similar to yours except I insulated the bottom and lid. I lose 1 F an hour
Posted in thread: Can you suggest a good, cheap pH meter? on 09-17-2014 at 03:09 AM
Dude, if you would spend 20 seconds googling the brand, you would see there are different
models. Mine was about 20 bucks more than his, still within his budget. Man, get a life.Stay
polite you punk.....
Posted in thread: Ward labs precision on 09-16-2014 at 12:23 AM
Ok so when they state that you your calcium is 20 ppm, it's not a number they picked within a
bracket of possible values ? It's the actual value they got then.
Posted in thread: Ward labs precision on 09-15-2014 at 11:49 PM
Just wondering how precise are ward labs results on tap water ? 21$ for a houshold mineral test
is damn cheap compared to other companies in Canada. I was quoted 150$ for a similar test here.
Is ward ...
Posted in thread: Slow sparge....help ! on 09-15-2014 at 09:00 PM
Update ! I built a copper manifold and set my mill to 0,039". I brewed the same recipe today
and all went well ! I believe the combination of a tight braid and very fine crush was the
Posted in thread: Slow sparge....help ! on 09-11-2014 at 11:00 PM
I already had one of those inner tubes...same problem happened. My braid is not collapsing for
sure since I have a spring inside of it. Bobby, i'm thinking compaction too but even before I
start the p...
Posted in thread: Slow sparge....help ! on 09-11-2014 at 01:32 AM
Well I don't have any picture of the grain milled at 0.025" but since I wet conditioned my
malt, I had whole intact kennels and lots of small white particles
Posted in thread: Slow sparge....help ! on 09-10-2014 at 08:52 PM
For the moment, I adjusted my mill to 0.039" and I might go back to a manifold. As for malt
conditioning, I don't think it could me my problem as it keeps the kennels for a better
filtration. Rekoob, ...