Gift Premium Subscription To maierhof

Join Date:


Last Activity:

03-26-2015 6:41 PM

Likes Given: 19

25 Likes on 23 Posts 


  • Posted in thread: New Freezer Busted? on 03-25-2015 at 06:12 AM
    IF you "converted" it - in my opinion that means cutting into it anywhere and adding at temp
    controller or anything like putting a hole in it - you have voided the warranty. If you did not
    cut into it...

  • Posted in thread: Stainless Steel Hop Spider on 03-25-2015 at 06:06 AM
    Lots of pro/con talk here...

  • Posted in thread: Beer line Cooler help needed on 03-21-2015 at 07:04 AM
    Your keezer is getting hot because it is running too often. This wastes energy and kills your
    compressor faster. 1 - Where do you have your temp sensor placed? It sounds as if your temp
    sensor is in a...

  • Posted in thread: 9 gallon kettles on 03-19-2015 at 01:32 AM
    I think im just gonna buy a bottle of oxygen and tap it with a hose. A five second blast of
    pure oxygen is all it will take and the bottle should last for a long time.Uh - you might want
    to do some mo...

  • Posted in thread: Help: 1st time brewing with a kegle setup on 03-17-2015 at 02:36 AM
    I couldn't tell the temp oh the sparge of water once the water level dropped below the temp
    probes level. .try buying a smaller temp probe then using a 4 way ss attach it to out of your
    keggle - cap ...

  • Posted in thread: 9 gallon kettles on 03-17-2015 at 02:08 AM
    Yeah i have been doing ``splash`` aeration by shaking the carboy, works really well. However i
    am going to cut out a little work and just buy a bottle of pressurized oxygen...then i can do a
    bit of in...

  • Posted in thread: Yeast Harvesting - the easy way on 03-16-2015 at 07:03 AM
    Ok - finally found time to BKF this thing thing to get them ready. Wow - again these things are
    really thin so doing the BKF was tough had to use the center hole in my main sink as a way to
    firm it up...

  • Posted in thread: Simple Yeast Storage Procedure on 03-15-2015 at 04:13 AM
    Quick, succinct, and to the point = Beautiful! Thank you!! :mug:

  • Posted in thread: 9 gallon kettles on 03-14-2015 at 08:22 PM
    I will definitely be using the three tier gravity method for now but i do plan on getting a
    pump down the line to take things to that next level. From what i have seen thus far is the
    gravity method s...

  • Posted in thread: Yeast Harvesting - the easy way on 03-14-2015 at 08:13 PM
    maierhof,I agree - soldering fittings on that lid is a little tricky. Since the lids are thin,
    it's a delicate balance between getting the fitting hot enough to get the solder to flow
    without overheat...


Newest Threads