VIEW MY

Maddyriver

Gift Premium Subscription To Maddyriver

Join Date:

11-08-2011

Last Activity:

10-29-2013 11:19 AM

    ABOUT ME

  • Male
  • Married
  • West Yellowstone
  • MT

LATEST ACTIVITY

  • Posted in thread: Starter temp vs carboy temp? on 03-11-2013 at 10:19 PM
    I've heard about folks using the cool down method, but I plan on pitching the entire starter
    (due to preference & time constraint). It makes sense to pitch at same temps, but I'm concerned
    that the te...

  • Posted in thread: Starter temp vs carboy temp? on 03-11-2013 at 09:24 PM
    I just started pitching starters. So far ale starters. I've been pitching the starters around
    70F. However, in the past, before using starters, I would generally pitch my ale yeasts around
    62F. Then l...

  • Posted in thread: Raising Fermentation Temp To Clean Up on 11-11-2012 at 08:49 PM
    Makes sense. Leaving it on carboy. Currently controller/carboy at target temp of 71F. Ambient
    79F. Seems to be stabilizing. Thanks again.

  • Posted in thread: Raising Fermentation Temp To Clean Up on 11-11-2012 at 04:19 PM
    I'm using a Brewer's Edge fermentation space heating pad stuck to inside wall of fridge being
    controlled by a Brewer's Edge controllerII. So the probe is currently place and insulated to
    outside of ca...

  • Posted in thread: Raising Fermentation Temp To Clean Up on 11-11-2012 at 03:21 PM
    Thanks guys. So it sounds alright to bring the temp up to 70-72F when active fermentation has
    slowed and the temp wants to drop. As it's not a big swing in temp. As for probe location
    during fermentat...

  • Posted in thread: Raising Fermentation Temp To Clean Up on 11-11-2012 at 05:19 AM
    Sorry, forgot to address another concern. Should probe placement still be insulated to side of
    carboy when raising the temp on the controller? Or should I dangle it in the chamber, and
    overshoot in am...

  • Posted in thread: Raising Fermentation Temp To Clean Up on 11-11-2012 at 05:16 AM
    When trying to raise the carboy temp after the initial days of fermentation to drop points and
    clean up what is a good duration for this step? This is pertaining to my current ale batch. I
    waited unti...

  • Posted in thread: Brewers Edge Controller II & Space Heater on 11-11-2012 at 04:59 AM
    Well figured out that I did have to switch jumpers. Heater works fine.

  • Posted in thread: Brewers Edge Controller II & Space Heater on 11-10-2012 at 10:56 PM
    Been trying to have my Brewers Edge controller II run a brewers edge space heater pad in my
    fermentation chamber, but pad dos not warm up. I plugged the pad into the controller hours
    again and set the...

  • Posted in thread: Pitching ale yeast at low temps on 11-06-2012 at 05:39 PM
    Cali yeast straight from vile. I've brewed quite a few all grain batches with this strain, and
    have always had fermentation begin within 12 hrs. My concern is that this time I pitched at a
    slightly lo...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS