Last Activity:06-29-2016 2:44 AM
Likes Given: 9
20 Likes on 18 Posts
Posted in thread: Doubling Down: SS Brewtech Conical + FTSS + Glycol Power Pack on 06-14-2016 at 12:45 AM
These are what I used (tip from conan71 earlier in this thread). Note I have two different
Chronicals, one of them is a BME and uses the 3/8" fittings, the other is a standard using a
cooling jacket. ...
Posted in thread: Sabco 15.5 gal half barrel stainless steel fermenter on 03-18-2016 at 08:20 PM
Posted in thread: Sabco 15.5 gal half barrel stainless steel fermenter on 03-16-2016 at 12:05 AM
What were you doing for temp control with this beast?Sorry, haven't been checking on HBT. As
far as temp control, I use a little insulated ferm room with a small ac unit for cooling and a
Posted in thread: Motorized Grain Mills: Time to show them off! on 03-15-2016 at 11:57 PM
In regards to speed, I actually thought I was going slow, but still with 10-11 lbs, it seemed
to chop it up pretty fast. I had the drill handle about a 1/4 of the way in. I think it may
have took me a...
Posted in thread: Whirlpool arm pick up tube on 03-09-2016 at 09:10 PM
Still have this if anyone is interested for $20 shipped
Posted in thread: Sabco 15.5 gal half barrel stainless steel fermenter on 03-09-2016 at 08:58 PM
I haven't been brewing as much lately so I'm selling my 1/2 barrel fermenter. This a great way
to ferment larger home brew batches, perfect for 7.5-10 gal but you can ferment up to 13 gal in
Posted in thread: Whirlpool arm pick up tube on 02-18-2016 at 06:23 PM
This is almost new, SS 5/8" OD (9/16" ID) with 1/2" NPT male threaded compression fitting.
Total length is 9" so you'd have about 8 1/2" +- of length once threaded into your fitting.
Could be used as ...
Posted in thread: HomebrewSupply Recipe Giveaway on 11-05-2015 at 02:44 PM
Belgian Pale Ale - all grain :-)
Posted in thread: Keg Connection New Inline Flow Control Valve Giveaway on 10-16-2015 at 04:40 PM
Posted in thread: Show us your sculpture or brew rig on 07-21-2015 at 02:18 AM
Nice. Your pump's upside down though. I'd keep a close eye on charring underneath the metal