Last Activity:05-23-2014 4:14 PM
Likes Given: 6
7 Likes on 6 Posts
Posted in thread: My crack at a keezer. on 03-10-2014 at 04:53 AM
Posted in thread: HomeBrewTalk 2014 Big Giveaway on 02-26-2014 at 12:32 AM
Woot! I am in!
Posted in thread: My Kal / Electric Brewery Build on 12-03-2013 at 04:30 AM
Looking good so far! ;-P
Posted in thread: Rebel Brewer Giveaway! on 11-22-2013 at 01:20 PM
Posted in thread: Soldering Stainless steel on 11-18-2013 at 01:39 PM
What do you do to clean everything before your first run? I used flux to clean up most of the
discoloration then soapy water... any other steps I should consider?
Posted in thread: Cheap Copper at Home Depot on 11-08-2013 at 03:22 PM
Didn't find any in Mpls/St. Paul area... only tried 2 stores though
Posted in thread: Soldering Stainless steel on 11-04-2013 at 02:41 PM
How big of a hole did you start with? I started with a 7/8" hole and it worked perfect.What
kind of heat source are you using? I didn't get that much discoloration of the stainless or
burning of the f...
Posted in thread: Soldering Stainless steel on 10-31-2013 at 10:01 PM
Might a slightly larger receiving die not create such a sharp bend at the dimple and be less
prone to cracking?Some of the other dimples posted here seem more gradual and not as abrupt. As
if the oute...
Posted in thread: Random electric components - MN on 10-31-2013 at 09:58 PM
Latest round shipped out, list updated, and messages replied to.
Posted in thread: Soldering Stainless steel on 10-30-2013 at 11:51 PM
I started with a 7/8" hole, but the greenlee punch for some odd ass reason leaves a little cut
out on the edge, not a perfect circle :-/ I am a bit disappointed with the performance, all my