Last Activity:12-10-2013 10:05 PM
Likes Given: 2
5 Likes on 3 Posts
Posted in thread: My < $10 Ghetto KAB4 Windscreen on 12-06-2013 at 12:52 PM
Me lacks the welding skills.I am fortunate enough to have a full maintenance shop at my work
that welded mine but usually muffler shops will do work on the side for some cash. Just cut the
welds with ...
Posted in thread: My < $10 Ghetto KAB4 Windscreen on 12-06-2013 at 05:45 AM
Or you could do like I did and cut the welds on the 4 parts of the stand and raise the burner
up and reweld it. Probably the same price give or take and that eliminated the need for a wind
Posted in thread: HELP!! problem with element placement in a keggle on 12-02-2013 at 03:46 AM
You guys are awesome. Always helpful and quick responses! I had the element on the inside of
the keg trying to decide where to put it and never thought about the fact it will sit back
another inch or ...
Posted in thread: HELP!! problem with element placement in a keggle on 12-02-2013 at 01:37 AM
I have run into a bit of a problem mounting the heating element in my keggle. Since the dip
tube comes out and bends down in the middle of the keg no matter where I try and find a spot to
mount the el...
Posted in thread: BYO BoGo List of 'wanters' 50/50 splits on 11-29-2013 at 07:44 PM
Got the card in the mail today so if anyone needs in just pm me.
Posted in thread: Show us your sculpture or brew rig on 11-25-2013 at 03:21 AM
Finished up the electric box last weekend and finished the stand this weekend.
Posted in thread: Trade my ball lock for your pin lock on 11-23-2013 at 09:05 PM
It would be better to do a local trade is why I am posting it here but I have a clean and ready
to go ball lock keg that holds air and I need to trade it for a pin lock keg. The ball lock is
too tall ...
Posted in thread: List of PJ Electrical Diagrams on 11-19-2013 at 04:13 AM
Loodachris,Wht are you using for your E stop? I do not se th switch on your panel picture. Is
it possible that you are using a normally closed switch? (closed contact when not activated) If
so that is...
Posted in thread: List of PJ Electrical Diagrams on 11-19-2013 at 04:11 AM
I put the E stop on top next to the heat sink but it's the Auber Instruments SW6 I think and
looking at it now I had it connected to the NC side which would make sense. I probably just did
all this re...
Posted in thread: List of PJ Electrical Diagrams on 11-19-2013 at 03:59 AM
That will work if it's bare metal and reliably connects to the rest of the box. The terminal
strip in the drawing is really just for illustration. You'd normally use something like a
grounding bar whi...