lgoolsby

LATEST ACTIVITY

• Posted in thread: Looking for enclosure mounting ideas on 11-26-2012 at 06:09 PM
  I am building a single tier rig similar to JonW's BCS controlled system, except I am building
  an enclosure to house all the electrical components. I am thinking of building some kind of
  mounting arm t...

• Posted in thread: Tips for a propane manifold on 10-22-2012 at 01:01 PM
  Simple answer is ½” black pipe should be sufficient.Long answer depends on a lot of variables
  that cannot be answered without knowing your specifics. Burner size, location of regulator,
  high pressure ...

• Posted in thread: Tips for a propane manifold on 10-21-2012 at 12:57 AM
  I am building a single tier system similar to JonW's and have a question about my gas lines. I
  am thinking about using one inch black pipe for the main manifold and then half inch for the
  lines to the...

• Posted in thread: Electric Burner Igniter on 09-10-2012 at 03:45 AM
  Any chance of getting a pic or explanation of how you used the igniter?

• Posted in thread: Single Tier, 3 Pump, BCS-462, Automated Rig on 09-10-2012 at 02:24 AM
  Brewed today with the new igniter system. It worked flawlessly! The BCS fires the igniters for
  a few seconds every time a gas valve opens. My standing pilot lights kept getting blown out by
  wind, so t...

• Posted in thread: My new brew system, a brutus 10 with some nice modifications on 09-10-2012 at 01:43 AM
  Subscribed.

• Posted in thread: Another Brutus System is Born on 08-21-2012 at 11:25 PM
  Any way you could go into a bit more detail about your ignition system?

• Posted in thread: Best idea for electric ignition on propane burners on 08-21-2012 at 01:39 PM
  I am building a BCS controlled single tier system similar to JonW's and am now starting to
  sweat out the details. One of the bigger details I am trying to figure out now is the burners.
  I currently ha...

• Posted in thread: Single Tier, 3 Pump, BCS-462, Automated Rig on 08-21-2012 at 01:19 PM
  Thanks Jon, that helps some. I am still a bit confused on what makes someone choose between an
  SSR and a relay board. Is it just a matter of preference or is it for systems that are 24V vs.
  120VAC. My...

• Posted in thread: Ignition Control Help on 08-21-2012 at 03:41 AM
  Looking for ideas on how to configure and install automated ignition control. More concerned
  with how to wire the igniters than I am with makes, although welcoming ideas for where to buy.
  I am connect...