Last Activity:09-17-2014 10:18 AM
Likes Given: 11
3 Likes on 3 Posts
Posted in thread: She wants my brewery on 04-22-2012 at 03:30 PM
give half the brewery take the valves off the pots and keep them and give her the pots. file
for primary custody of the kids and make her pay child support
Posted in thread: DIY Mashtun Thermowell - easy and cheap on 04-16-2012 at 07:20 PM
you may want to stay away from copper during and post fermentation quoted from is a
double-edged sword in brewing. It is beneficial before fermentation, but detrimental
afterwards. Copper ions react...
Posted in thread: Inexpensive (but good) reverse osmosis system? on 04-04-2012 at 04:28 AM
Depends on if you know your tap water profile and if your trying to make a certain profile in
Posted in thread: Another keezer question on 03-19-2012 at 01:49 AM
i put one in with a 2x6 collar but necessary i dunno
Posted in thread: Inexpensive (but good) reverse osmosis system? on 03-14-2012 at 10:55 PM
I bought a dupont one from menards for like $100 easy install 30 min because i ran an
additional line one for the kitchen and one for brew room
Posted in thread: Passive oxide layer on new aluminum pot on 03-02-2012 at 04:40 PM
I have never done this to my pot, I still have the dull gray oxide layer and never noticed any
metallic off flavors. I guess I'll give it a try and see if I can taste any difference.
Posted in thread: Help: Keg mold emergency! on 02-20-2012 at 04:01 PM
the beer should still be good. Just clean it up again. look for any air leaks in your kegerator
that may be drawing in moisture and use some damp-rid and you should be set
Posted in thread: ibrewmaster help on 02-18-2012 at 04:16 AM
are either your spage or infusion out settings listed as initial or step?
Posted in thread: ibrewmaster help on 02-18-2012 at 04:08 AM
mine doesn't seem to re calculate if you have both entered the show the same as if you entered
on or the other i have on medium infusion in 17.5medium infusion out at 9.1or sparge 15.1 if
you go the s...
Posted in thread: ibrewmaster help on 02-18-2012 at 12:07 AM
did you select freeform or autocalc?