Gift Premium Subscription To kopper

Join Date:


Last Activity:

02-21-2014 1:24 PM

Likes Given: 1

2 Likes on 2 Posts 


  • Posted in thread: Spike Brewing 12.5 Gallon Conical Fermenter Giveaway! on 01-06-2014 at 01:14 PM
    Awesome! Thanks Spike!

  • Posted in thread: Weldless Triclover Element? on 09-27-2013 at 03:01 PM
    Bobby, will the solder on tri-clover flange only be available in 1.5"?

  • Posted in thread: 1" couplers or nuts? on 08-28-2013 at 10:21 PM
    How about a tri clover fitting ? This setup is a dream for e kettles . Simply unclamp it to
    take the element out. Can also end cap it and use on a regular burner. Your not married to
    electric only. d...

  • Posted in thread: Weldless Triclover Element? on 08-28-2013 at 10:15 PM
    Bobby,I'm very interested in one of these. The typical weldless device involves only a gasket
    and screw-on nut that you tighten down to effect a water-tight seal. Is it due to the diameter
    of these th...

  • Posted in thread: I need a Quick Disconnect for 1-1/4" CPVC on 05-09-2013 at 02:26 AM
    How "quick" of a disconnect do you need? What about just a union or if you need flow control a
    true union ball valve? About the same amount of time to disconnect as a tri-clamp. I use them
    in my aquar...

  • Posted in thread: 30 amp breaker help on 05-03-2013 at 12:28 PM
    I'm questioning your capacity - is 30 amps enough?. What is the highest wattage requirement of
    your heating elements? As an example, if you have 4500 watt elements, you'll need 40 amp
    breakers (4500 w...

  • Posted in thread: My 30A GFI breaker wouldn't reset, even w/ no load on 04-30-2013 at 12:58 AM
    It just seems like a clamp being too tight isn't the source of the issue. If you can swap the
    wiring out that easily I would. JMO.

  • Posted in thread: My 30A GFI breaker wouldn't reset, even w/ no load on 04-28-2013 at 09:12 PM
    I must have missed something. Why did loosening the clamp solve the problem? The way I
    interpret the solution makes me think there is a short there for some reason?

  • Posted in thread: A Novice call for help... on 04-27-2013 at 12:34 PM
    4. I bought the $28 shipped setup off ebay to dabble. It worked pretty well for heating mash
    and strike water actually but i already purchased an RTD from Auber to get better accuracy and
    Celsius in t...

  • Posted in thread: A Brewing Water Chemistry Primer on 04-24-2013 at 12:15 PM
    Any suggestions on storage of ro/di water prior to brewing? Since it usually takes many hours
    to accumulate enough water to brew, my thoughts were to make it in either a plastic water
    barrel or possib...