Gift Premium Subscription To koldk

Join Date:


Last Activity:

11-17-2013 3:02 AM


  • Hastings, ON
  • Computer Geek
  • Male
  • In a Relationship


  • Posted in thread: Gas Distributiion help on 10-23-2010 at 03:13 PM
    It sounds like I have a very similar set up to you. Definitely do not need multiple 30psi
    regulators. I have mine turned down...not sure how much...but I suspect to around 15-20 psi.
    Catt22 has descri...

  • Posted in thread: malt substitution chart? on 01-31-2010 at 02:00 PM
    Exactly what I was hunting for! I do see one correction...crystal 10's wyermann equivalent is
    carahell according to KotMF. Thank you for sharing this!

  • Posted in thread: Question about building a Propane Manifold on 11-19-2009 at 08:01 PM
    I think you have just about everything you need. I used everything you plan to and my set up
    works great. The one thing I see missing is the pipe dope used for gas fittings. Have fun!

  • Posted in thread: Homemade distribution manifold on 09-04-2009 at 07:48 PM
    My old man uses copper tubing for the air lines in his shop. I'm not advocating it, but he's
    successfully fed 120psi air through the system for 8+ years without issue. So long as you are
    regulating th...

  • Posted in thread: Can I save PBW water in Cornies? on 07-10-2009 at 04:47 PM
    I just listened to a Brewing Network Podcast where this exact question was asked of a 5-Star
    chemical engineer. He didn't recommend it, although he said he'd done it, but using distilled
    water. Their ...

  • Posted in thread: Advice needed on Gas line setup on 04-28-2009 at 04:34 PM
    The ball valves will work, but if your looking for easy tweaking, you may want to get the
    needle valves. I run the same burners with 1/2" pipe feeding them. I adjust with a 1/2" ball.
    It can be done, ...

  • Posted in thread: How much have you spent on equipment? on 04-01-2009 at 11:43 PM
    I don't want to add it up. I can't lie to the SWMBO if I myself don't know the truth

  • Posted in thread: Propane Solenoid Valve on 04-01-2009 at 04:55 PM
    If I'm reading their catalog right, they are rated for 2 psi. They might work, if your using
    low pressure. I myself snagged up an 8210 model series. They seem to work well with the ~30 psi
    propane I h...

  • Posted in thread: Looking for gas flare fitting... on 04-01-2009 at 04:33 PM
    I had the same problem. I ended up getting a stainless steel flex gas line kit from Home Depot.
    The kit has 2 3/8" to 1/2" adapters, but I ended up only using one. Not a cheap route. I think
    it was $2...

  • Posted in thread: BLING BLING Electric HERMS Conversion on 02-17-2009 at 06:29 PM
    Congrats on having your sweet set up featured in the new BYO issue!

Following Stats