VIEW MY

klyph

Gift Premium Subscription To klyph

Join Date:

12-09-2009

Last Activity:

06-03-2014 12:56 AM

Referrals: 1

Likes Given: 3

38 Likes on 34 Posts 

    ABOUT ME

  • North Pole, Alaska
  • Male
  • Single

LATEST ACTIVITY

  • Posted in thread: Request for Steam Ventillation Information on 05-09-2014 at 04:49 PM
    had this made by an hvac sheetmetal shop. It works well, requires no fan, gets about a gallon
    per hour boiloff. Initially there will be some condensation that runs down the inside of the
    cone until ...

  • Posted in thread: Here it is...Massive April of Fools Sale - Nor Cal Brewing Solutions 25% Off on 04-18-2014 at 02:00 AM
    Perfect timing Jay, I'll take a code.Thanks!

  • Posted in thread: Stovetop 110v single vessel system on 09-04-2013 at 04:59 PM
    I only use the stove heat when mashing, the element doesn't come on until I remove the bag.With
    the manifold I use whole hops, so the recirc port is more to just stir for even temps than to
    create a w...

  • Posted in thread: Stovetop 110v single vessel system on 10-11-2012 at 05:40 PM
    Ha, no problem, this thread certainly veered off into left field.What element are you using in
    your pot? Any problems with it?It's a 1500w camco I believe. No problems so far.

  • Posted in thread: Stovetop 110v single vessel system on 07-15-2012 at 05:54 PM
    Thanks for posting your setup. Have you had any problems with the pvc cap on the backside of
    your element getting hot? How did you connect your ground wire?Thanks for staying on topic
    :mug:I keep the ...

  • Posted in thread: Stovetop 110v single vessel system on 06-29-2012 at 09:18 AM
    Beer.

  • Posted in thread: 120 V Electric Brewery on 06-25-2012 at 07:18 PM
    If you can utilize your stove range as the second element, it greatly simplifies the setup, and
    you only need it for the boil.

  • Posted in thread: RIMS Build on 06-12-2012 at 08:26 AM
    The trickiest part is controlling the temperature in the MLT, which wants to get way too hot
    with the 5500 watt ULWD element in the RIMS. I'm considering going to a lower wattage element -
    any comment...

  • Posted in thread: RIMS for Dummies on 06-12-2012 at 08:17 AM
    make sure manual mode is OFFI thought I had all the settings to factory but when I went through
    the menus I had the A-M set to 0 (manual) instead of 2, the factory setting.:ban::tank::mug:

  • Posted in thread: RIMS for Dummies on 06-11-2012 at 09:10 AM
    First, set OutH=100, (the default), it should be left that way unless you have a massively
    overpowered heating element, then make sure manual mode is OFF. Then set At=2 which will engage
    the Auto Tune...

FORUM SIGNATURE
10 gallon electric system Stovetop 110v single vessel 5 gallon system Primary: saison Secondary: nada Conditioning: macaroon stout Drinking: store bought
0 COMMENTS
POST A COMMENT