kitemanks

LATEST ACTIVITY

• Posted in thread: Guinness Draught Clone on 02-28-2013 at 09:24 PM
  You are correct.the secret to this brew is to thin it with temps. A long protien rest and then
  mash at 150 ish. That is if your going for the Guiness Draught style the extra stout is
  different. You ca...

• Posted in thread: HomeBrewTalk 2013 Big Giveaway! on 02-09-2013 at 03:31 PM
  Nice, and new things for my want list too!!!:ban::mug:

• Posted in thread: My ongoing basement bar build on 12-01-2012 at 09:50 PM
  How far away from your freezer is the tree?? I would consider running a large diameter pvc pipe
  (same diameter as your tree) from your freezer to and possibly into the tree allowing the
  freezer to kee...

• Posted in thread: Starting my electric basement brewery! on 12-01-2012 at 09:18 PM
  Nice start. It looks like a lot to do. I was lucky when I did mine I had carpet and pad which I
  tore up in one day. I cleaned the concrete and then got one of those garage paint kits and put
  that down...

• Posted in thread: My Weldless Build Using Strut on 11-10-2012 at 02:42 AM
  In my area I have to buy the strut material at HD, Lowes, or Menards. The struts are in the
  electrical dept. and are 18.96 at my retail locations. Commerical plumbing and electrical
  stores that sell t...

• Posted in thread: My Weldless Build Using Strut on 11-08-2012 at 01:38 AM
  Darkness I would also like to see a close up of your wheel mounting solution. I will be
  mounting my wheels with the strut in the same configuration. I'm not sure about using right
  angle brackets, and ...

• Posted in thread: My Weldless Build Using Strut on 11-08-2012 at 01:32 AM
  Darkness, I see that you have some keggs covered in bubble wrap and then stretch wrapped. I
  have used the industrial strength sticky backed 1 1/2 in wide or so velcro from Wal-Mart and it
  makes wrappi...

• Posted in thread: My Weldless Build Using Strut on 11-04-2012 at 03:51 PM
  I also guess I need to thank you for the overall thread too. I switched to 10 gallon batches a
  while ago but still use my old 5 gallon home-made sculpture. I still only use a 10 gallon
  electrified coo...

• Posted in thread: My Weldless Build Using Strut on 11-04-2012 at 03:34 PM
  I have mine shielded from the wind and I also fire in the garage. The boil kettle bottom should
  normally be quite aways from the tip of the blue flames this allows all of the little flames to
  make one...

• Posted in thread: My Weldless Build Using Strut on 11-03-2012 at 09:32 PM
  I fire my 20 gallon boil kettle with a slightly larger jet burner. FYI the burner I have has to
  be 15 inches below the cooking surface for maximum efficiency and correct burn. A good way to
  tell is th...