VIEW MY

kimeye01

Gift Premium Subscription To kimeye01

Join Date:

11-09-2011

Last Activity:

03-26-2012 3:24 PM

Referrals: 1

    ABOUT ME

  • Single
  • Louisville
  • KY

LATEST ACTIVITY

  • Posted in thread: Set and Forget at 70 degrees then cool to 40....question on 03-26-2012 at 08:24 PM
    Excellent, thanks!

  • Posted in thread: Set and Forget at 70 degrees then cool to 40....question on 03-26-2012 at 05:31 AM
    My keezer temperature is not regulated yet so I am force carbing my beer (with the set and
    forget method) at room temperature (70 degrees) and will later cool the beer.My question is,
    what temperature...

  • Posted in thread: Can a REALLY skunky beer hurt you? on 01-27-2012 at 01:56 PM
    This is good information to know. Thanks!FYI: I tried it last night and it wasn't nearly as bad
    as I was prepared for. In fact, I rather like it.

  • Posted in thread: Can a REALLY skunky beer hurt you? on 01-26-2012 at 12:06 AM
    I've been fermenting a poorly boiled brown ale for over 1.5 years and finally kegged it. I
    didn't have hopes that it would actually taste good however I want to make sure there is no
    potential for phy...

  • Posted in thread: Is it bad to use Oxyclean frequently? on 01-24-2012 at 04:32 AM
    I have been using Oxyclean to clean my fermenting bucket, corny kegs and tubing after every
    use. Is this too frequent? Are there any health issues to worry about?

  • Posted in thread: Question about Sanitizing Dip Tube in Corny on 01-22-2012 at 08:25 PM
    I need to get a bigger wrench and give it another try. If that doesn't work, I'll try to force
    the sanitized water up the tube and hope for the best.Thanks for all the advice!

  • Posted in thread: Question about Sanitizing Dip Tube in Corny on 01-22-2012 at 07:53 PM
    Does anyone know how to sanitize the dip tube in a corny keg without using gas? This is my
    first time kegging. I haven't filled my Co2 tank yet but want to get my brew out of the
    fermenter and into my...

  • Posted in thread: Guide to set internal chest freezer thermostat to >32F; Eliminate external control on 01-22-2012 at 06:24 PM
    Hi, does anyone know where the coarse adjust screw is located on a GE 7 cu ft freezer?

  • Posted in thread: Did I Ruin My Beer? on 01-22-2012 at 12:07 AM
    Haha, true. I will try again tomorrow then. Thanks.

  • Posted in thread: Did I Ruin My Beer? on 01-21-2012 at 11:56 PM
    I opened the lid of my fermenter briefly today but sealed it back on. Will my beer still be
    good tomorrow to siphon into a keg? Or do you think that the oxygen has ruined it?I am kegging
    my beer for t...

0 COMMENTS
POST A COMMENT